Living Spaces Summit Bed Frame Assembly Instructions
Model: 7030-00453 KIT (MAS90: 5043-43240)
Product Models
This assembly guide covers the following Summit bed models:
- 4650/4651/4652 TWIN PANEL BED
- 4655/4656/4657 FULL PANEL BED
- 4650/4653/4654 TWIN BKCS BED
- 4655/4658/4659 FULL BKCS BED
Hardware Kit
| QTY: | DESCRIPTION: |
|---|---|
| 8 | 100MM DECORATIVE HEAD LAG BOLTS |
| 1 | 4MM ALLEN WRENCH |
| 10 | 6 X 1 1/4" PHIL FLAT PARTICLE BOARD SCREW |
| 1 | 4MM POWER DRILL DRIVER |
Visual representation of hardware: A lag bolt, a 4mm Allen wrench, a Phillips flat particle board screw, and a 4mm power drill driver.
Assembly Overview
Assembly Time: 30 Minutes
Recommended Persons: 1 Person
Tools Required:
- 4 mm Allen Wrench (INCLUDED)
- 4 mm Allen Drill Bit (Ensure the bit is fully seated into the bolt head before turning)
- Phillips Head Screwdriver
Recommendation: Using a power driver with the drill bit is recommended if available.
Important Notes:
- Ensure that lag bolts are started into the holes on the frame rails during assembly.
- Do not fully tighten bolts until the assembly is loosely complete.
Parts List
Please verify you have all parts before beginning assembly. Contact your dealer if any part is missing.
- A) 8 – 100mm Decorative Head Lag Bolts
- B) 1 - Headboard Assembly
- C) 1 - Footboard Assembly
- D) 2 - 5 1/4" x 75" Mattress Rails w/Support Cleats
- E) 3 - 3 1/2" x 38 3/4" (Twin) OR 3 - 3 1/2" x 53 3/4" (Full) Loose Slats
- F) 10 - 1¼" Wood Screws
- G) 1 – 4mm Driver for power drill
Diagram Description:
The diagrams show the general structure of the Twin Panel Bed and the Full BKCS Bed. Key components are labeled: 'B' indicates the Headboard Assembly, 'C' indicates the Footboard Assembly, 'D' indicates the Mattress Rails, and 'E' indicates the Loose Slats.
Assembly Steps
- Attach mattress rails (D) to the headboard (B) and footboard (C) using eight lag bolts. Tighten securely.
- Spread the slat roll across the bed frame from end to end. Place wood screws in the four outside corners, ensuring the slats are pushed tightly against the footboard/headboard. Place three additional loose slats into the gaps within the slat roll and secure them with wood screws. Refer to the following pages for detailed slat installation information.
- Add the appropriate thickness innerspring bunk mattress. Consult Living Spaces for specific mattress recommendations.
Slat Installation Details
When using a slat roll, three individual slats should be positioned evenly within the existing gaps and underneath the strapping before fastening.
Installation with Bunkie Board:
For installation of individual slats when using a Bunkie Board (sold separately), consult your retailer for purchase information. The diagram shows screws securing individual slats.
Installation with Slat Roll:
For installation of individual slats when using a Slat Roll (sold separately), consult your retailer for purchase information. The diagram illustrates screws being used to fasten individual slats into place.
