IKEA MELODI Pendant Lamp
Design and Quality IKEA of Sweden
Important Safety Information
IMPORTANT! Always shut off power to the circuit before starting installation work. In some countries, electrical installation work may only be carried out by an authorized electrical contractor. Contact your local electricity authority for advice.
Assembly Instructions
Follow these steps carefully to assemble and install your MELODI pendant lamp.
Step 1: Prepare the Lamp
Ensure the power is disconnected. The lamp shade is shown with a cord and a connector. A close-up shows the connector being inserted into a socket.
Step 2: Secure the Cord
A diagram shows the lamp cord passing through the lamp shade. A close-up shows a clip being used to secure the cord at a specific height.
Step 3: Attach the Mounting Bracket
A hand is shown attaching a mounting bracket to the cord, with arrows indicating the direction of movement.
Step 4: Route the Wires
Diagrams show the wires being routed through the mounting bracket and secured.
Step 5: Secure the Cord Further
The cord is shown being secured with a component, with a close-up indicating a specific attachment point.
Step 6: Prepare for Hanging
A diagram shows a hook being used to hang the lamp assembly. A measurement is indicated: 20-40 mm (25/32" – 1"37/64).
Step 7: Connect the Wires
The wires are shown being connected using a terminal block. A diagram illustrates the correct connection for Line (L) and Neutral (N) wires. Arrows indicate the insertion of wires into the terminal block.
Step 8: Final Connection
The wires are shown being connected to the terminal block, with an audible 'Click!' indicating a secure connection. A diagram shows the correct way to insert the wires.
Step 9: Wire Connections (Detail)
Detailed diagrams show the process of inserting the Line (L) and Neutral (N) wires into the terminal block, ensuring correct polarity.
Step 10: Secure the Connection
The connection is shown being secured with a click, indicating it is properly locked in place.
Step 11: Adjust and Tighten
A hand is shown adjusting and tightening a component on the cord. Cautionary text in multiple languages advises not to overtighten.
Step 12: Final Assembly
The lamp shade is shown being attached to the main assembly, with a 'Click!' indicating it is secured.
Caution: Do not overtighten.
