Electric Windscreen Controller

Preparation

Secure the bike on a stand.

Remove the windscreen.

Remove the plastic covers from the dashboard holder.

Locate the dashboard connector.

Visual Description: The initial steps involve preparing the motorcycle, including securing it on a stand, removing the windscreen, and accessing the dashboard area by removing plastic covers to locate the main dashboard connector.

Step 1: Purple Wire Connection

Cut the Purple wire approximately 2.5cm (1 inch) from the connector.

Connect the EWA Green wire to the Purple wire end that leads to the dashboard. Use a yellow butt connector.

Visual Description: A close-up image shows the purple wire cut, with the EWA green wire connected to the dashboard-bound end using a yellow butt connector.

Step 2: Blue Wire Connection

Connect the EWA Blue wire to the Purple wire end that is at the wiring harness side. Use a yellow butt connector.

Visual Description: Another connection is shown using a yellow butt connector, where the EWA blue wire is attached to the wiring harness side of the purple wire.

Step 3: White Wire Connections

Cut the White wire approximately 2.5cm (1 inch) from the connector.

Connect the EWA White wire to the White wire end that goes to the dashboard. Use a yellow butt connector.

Connect the EWA Yellow wire to the White wire end that is at the wiring harness side. Use a yellow butt connector.

Visual Description: Two white wires are depicted connected with yellow butt connectors. The EWA white wire is connected to the dashboard-bound white wire, and the EWA yellow wire is connected to the wiring harness side of the white wire.

Step 4: USB Connector Integration

Plug the EWA connectors in-line with the USB connector.

Visual Description: The EWA connectors are shown being integrated in-line with the motorcycle's USB connector.

Step 5: Unit Mounting

Typical position for the Electric Windscreen Adjuster.

Secure the unit properly.

Visual Description: The Healtech EWC Controller unit is illustrated in its recommended mounting location, ensuring it is securely fastened.