PS Eliminator Supplementary Manual

This supplementary manual provides installation instructions for the Healtech PS Eliminator module on the Kove 800X ABS Rally 2025 model (PSE-01).

Important: Ensure you have the correct model and follow all safety precautions before beginning installation.

Installation Steps

Step 1: Prepare the Motorcycle

Secure the Kove 800X ABS Rally motorcycle on a stable stand. This ensures the bike is upright and stable during the installation process.

Visual Description: The first image shows the Kove 800X ABS Rally motorcycle parked securely on a workshop stand, ready for maintenance. The second image provides another angle of the motorcycle.

Step 2: Access the PAIR Valve Area

Remove the motorcycle's seat. Then, carefully remove the side fairings to gain access to the necessary components.

Step 3: Locate and Disconnect the PAIR Valve Connector

Locate the stock PAIR (Programmable Air Injection) valve. This valve is typically found under the fuel tank. Unplug the electrical connector attached to it. The connector is described as a green, 2-pole connector.

Visual Description: The third image shows a close-up of the motorcycle's engine bay, specifically highlighting the green, 2-pin electrical connector for the PAIR valve, situated beneath the fuel tank.

Step 4: Remove the Stock PAIR Valve

Carefully remove the stock PAIR (clean air) valve from its mounting location.

Step 5: Connect the PSE Module

Take the Healtech PSE module and plug it directly into the motorcycle's wiring harness connector that was previously disconnected from the stock PAIR valve.

Visual Description: The fourth image displays a close-up of the motorcycle's wiring harness connector, ready to receive the PSE module.

Step 6: Secure the PSE Module

Ensure the PSE module is securely fastened in its designated location, preventing it from moving or becoming disconnected during riding.

For further information and support, visit the Healtech Electronics website.

www.healtech-electronics.com