HAVSDUN Wall Light Installation Guide

Safety Precautions and Warnings

⚠️ CAUTION: Before starting installation, turn off power at the main circuit panel.

⚠️ CAUTION: The light source of this product is non-changeable Light Emitting Diodes (LED). Do not disassemble the product, as the LEDs can cause eye damage. Do not immerse the product in water.

Regulatory Compliance

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.

❗ WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Parts and Tools

Required Tools:

• Screwdrivers (Phillips head and flathead indicated in diagrams)

Included Parts:

• Mounting Bracket (1x)
• Light Fixture Body (1x)
• Screws (2x)
• Wiring Connectors (3x indicated in Step 6)
• Wall Plate (1x)
• Light Shade (1x)

Diagram Description: The initial diagram shows two screwdrivers: one with a cross-head tip (Phillips) and one with a flat tip (flathead). The parts list diagram shows the main components with quantities.

Installation Steps

Step 1: Prepare the Light Shade

Diagram Description: The cylindrical light shade is shown being detached from the internal mechanism. Close-up views highlight release clips that secure the shade, indicating they need to be disengaged.

Step 2: Attach Mounting Bracket to Wall Plate

Diagram Description: The internal housing of the light fixture is shown being attached to a wall plate using two screws. A close-up view illustrates a screwdriver tightening a screw.

Step 3: Prepare Wall Plate

Diagram Description: A wall plate with a central hole is shown. A screwdriver is used to insert a screw from the front into a fixture component.

Step 4: Route Wires

Diagram Description: The mounting bracket is shown with wires being fed through the designated openings in the wall plate.

Step 5: Connect Wall Plate to Fixture

Diagram Description: The wall plate, with wires passing through, is shown being brought towards the main fixture body. An arrow indicates the attachment point. The material of the fixture body is marked 'PC'.

Step 6: Wire the Fixture

Diagram Description: This step illustrates the electrical connections. Three types of wires are identified: 'Live' (Phase/Con corriente), 'Neutral' (with tracer/Neutre/Neutro), and 'Earth/Ground' (Terre/Tierra). The diagram shows three wire connectors, and a close-up demonstrates twisting the corresponding wires together securely within each connector.

Step 7: Secure Fixture to Wall

Diagram Description: The assembled fixture is shown being attached to the mounting bracket on the wall using screws. A close-up view shows a screwdriver tightening a screw.

Step 8: Attach Light Shade

Diagram Description: The cylindrical light shade is shown being slid onto the fixture body. Text 'Click!' indicates the sound of it locking securely into place.

Step 9: Final Check

Diagram Description: The completed installation is shown. A hand is depicted turning a small knob on the fixture. Accompanying icons suggest the fixture has a dimming function, allowing adjustment of light intensity.

Operation

The HAVSDUN wall light features adjustable brightness. Turn the knob on the fixture to control the light intensity.