HAVSDUN

Safety and Installation Warnings

CAUTION: Before starting, turn off power at the main circuit panel. [power-off symbol]

CAUTION! The light source of this product is non-changeable light diodes (LED). Do not disassemble the product, as the light diodes can cause damage to the eyes. Do not immerse in water.

WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

FCC Compliance

This device complies with part 15 of the FCC Rules. Operation is subjected to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation.

Parts and Tools Overview

Required tools typically include a Phillips head screwdriver and a flat head screwdriver. ?

Included components:

• Mounting bracket (1x)
• Lamp body with integrated LED light source
• Screws (2x) for mounting bracket
• Wire connectors

(Diagrams show the lamp shade, mounting plate, screws, and tools.)

Assembly Steps

Step 1: Attach Lamp Shade to Base

The cylindrical lamp shade is designed to clip onto the mounting base. Align the shade with the base and push it upwards until it securely clicks into place. ℹ️ This step involves engaging internal clips.

(Visual: A hand pushes the cylindrical lamp shade upwards onto a base unit. Close-up views show clips engaging.)

Step 2: Mount Bracket to Wall

Position the mounting bracket against the wall or electrical junction box. Route the electrical wires from the wall through the designated opening in the bracket. ℹ️ Ensure the bracket is oriented correctly to accommodate the wiring.

(Visual: The mounting bracket is shown being positioned against a wall surface or junction box, with wires passing through.)

Step 3: Secure the Mounting Bracket

Use the provided screws to firmly attach the mounting bracket to the wall. ? Tighten the screws securely.

(Visual: A screwdriver is used to tighten screws into the mounting bracket, securing it to the wall.)

Step 4: Connect Electrical Wires

Connect the wires from the lamp to the corresponding wires from the power supply. The connections are typically:

• Live/Phase/Con corriente: Connect to the power supply's live wire.
• Neutral/Neutre/Neutro: Connect to the power supply's neutral wire.
• Earth/Ground/Tierra: Connect to the power supply's earth/ground wire for safety.

Use wire connectors to ensure all connections are secure and insulated. ℹ️ The diagram shows three wire connections being made.

(Visual: Close-up views of wires being connected to terminals, with three connections indicated.)

Step 5: Attach Lamp Housing to Bracket

Carefully align the lamp housing with the mounted bracket. Guide the wires into the housing as you attach it. ℹ️ The housing slides onto the bracket.

(Visual: The main lamp housing unit is shown being slid onto the already mounted bracket, with wires passing through the opening.)

Step 6: Finalize Lamp Housing Attachment

Secure the lamp housing to the mounting bracket using the provided screws. ? Tighten the screws to ensure the housing is firmly attached.

(Visual: A screwdriver is used to tighten two screws, securing the lamp housing to the bracket.)

Step 7: Complete Installation and Operation

Once the lamp housing is secured, the installation is complete. The lamp is likely operated via a built-in switch or dimmer. ? The diagram indicates that the light intensity can be adjusted.

(Visual: A hand interacts with a control on the lamp, showing a light bulb icon with arrows indicating adjustment of light brightness.)

(The lamp shade is then shown fully attached, with light emanating.)

(The text "Click!" is shown near the point where the shade attaches, indicating a secure fit.)