VidaLite 4 Head Track Pendant

Important Information

Read all the instructions included before installing the fixture. Retain this document for future reference.

Safety Warning

Turn off the power at the main fuse/breaker panel before beginning installation to avoid electrical shock. Do not install the fixture on an unfinished ceiling. Ensure a stable and secure surface before installing. Wear gloves while installing the fixture. Indoor installation only.

Diagrams

Figure 1: Mounting Components

This diagram illustrates the components used for mounting the fixture to the ceiling. It shows the relationship between the "Mounting Screw", "Mounting Bracket", "Stem", and "Canopy".

Figure 2: Electrical Box Connection

This figure depicts the electrical junction box (J-Box) installed in the ceiling, with wires extending from it, ready for connection to the pendant light.

Figure 3: Wiring and Stem Attachment

This diagram shows the detailed wiring process. It illustrates connecting the fixture's "Black wire" to the hot power line and the "White wire" to the neutral power line, using wire nuts. A ground wire connection is also indicated. The stems are shown attached to the fixture body, with labels "L" (likely Live/Hot) and "N" (likely Neutral) visible on the wiring.

Figure 4: Completed Installation

This illustration shows the VidaLite 4 Head Track Pendant fully installed and mounted on the ceiling, with its four adjustable track heads visible.

Installation Steps

1. Turn off the power.
2. Carefully separate the mounting bracket from the canopy, install mounting bracket to J-Box with mounting screws.
3. Thread two stems to the fixture, adjust suitable height and lock the set screw.
4. Connect the fixture to a suitable ground in accordance with local electrical codes.
5. Connect the White wire to the neutral power line wire with a wire nut.
6. Connect the Black wire to the hot power line wire with a wire nut.
7. Neatly place all wires and wire nut connections inside the J-box.
8. Install canopy to ceiling with four flat screws.
9. Turn on the power.