ASSEMBLY INSTRUCTIONS

Required Tools

Allen Wrench (Provided, Part F) ?

Phillips Screw Driver (Not Provided) ?

Before You Start

1. Check the hardware against the hardware list to make sure all items are present. ✔️
2. Assemble your furniture on a soft, flat surface to avoid scratching the finish.
3. ⚠️ CAUTION: Do not over tighten screws, nuts or bolts during assembly.
4. Your furniture may require occasional tightening.

Instructions

Diagram Description: A line drawing of a round coffee table with four legs and a lower shelf. The legs have casters at their base.

1. Turn the table on to a clean soft surface.
2. Attach bottom shelf to the legs using Bolt (B), Lock Washer(C), Flat Washer (D) and tighten all bolts using Allen Wrench (F). As shown in Figure 1.

   Figure 1 Description: Illustrates attaching the bottom shelf to the legs. It shows a close-up of a leg with holes, a bolt (B), a lock washer (C), and a flat washer (D) being inserted, with an Allen wrench (F) tightening it.

3. Attach the Casters (G) to the bottom shelf using Screw (E). As shown in Figure 2.

   Figure 2 Description: Illustrates attaching the casters. It shows a close-up of the underside of the bottom shelf where a caster (G) is being secured with a screw (E) using a screwdriver.

4. Attach the legs to the top using Bolt (A), Lock Washer (C), Flat Washer (D) and tighten all bolts using Allen Wrench (F). As shown in Figure 3.

   Figure 3 Description: Illustrates attaching the legs to the tabletop. It shows a close-up of the tabletop attachment point, a bolt (A), a lock washer (C), and a flat washer (D) being inserted into a leg, with an Allen wrench (F) tightening it.

5. Tighten all bolts before setting table back up right.

Hardware List