Sealey LED Twist Rechargeable Inspection Light

Introduction

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product, if used according to these instructions and properly maintained, will provide years of trouble-free performance.

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

1. Safety

1.1. General

• ✔️ Ensure the torch is fully charged before initial use.
• ❌ DO NOT turn the torch on when it is being charged.
• ❌ DO NOT shine directly into your, other person's or an animal's eyes.
• ❌ DO NOT allow children to use the torch.
• ❌ DO NOT handle or move the torch whilst it is being charged.
• ❌ DO NOT use the torch if you suspect that the battery, the torch casing or the cable is damaged. Consult your Sealey Stockist.
• ❌ DO NOT leave battery in a discharged state; recharge battery immediately. Before storage, fully recharge the battery, subsequently recharge the battery at least once every six months of non-use.

1.2. Battery Safety

• ⚠️ WARNING! To reduce the risk of burns or fire:
• ❌ DO NOT attempt to open, dismantle, modify or service the battery pack.
• ❌ DO NOT crush, puncture, short external contacts or dispose of in fire or water.
• ❌ DO NOT expose to temperatures above 40°C or below -10°C.
• ❌ DO NOT expose to direct sunlight for long periods of time.
• ❌ DO NOT expose to moisture.

• ⚠️ WARNING! DO NOT place the torch face down while in use.
• ✔️ Replace only with the battery pack designated for this product.
• ✔️ Recycle or dispose of used battery as stipulated by local regulation.
• ✔️ If the electrolyte in the cells gets on your skin, wash thoroughly with water. If it gets in your eyes, rinse thoroughly with cool water and seek immediate medical attention.

2. Introduction

Super bright SMD LED top light and SMD LED torch. The light body twists 360° and the light arm tilts 180° to provide light at any angle. Features a magnet on the rear and a rubber-covered magnet on the base, which allow hands-free operation. Uses a Lithium-ion battery for longer life, no memory effect, and a much slower discharge than traditional Ni-MH batteries. An easy-to-read charge indicator displays the battery level during use and while charging. Offers long operating times and charges via a USB Type-C cable (Supplied).

Diagram Description (LED201G Shown): A handheld inspection light with a twistable head and a magnetic base, featuring the Sealey logo and 'LED TWIST' branding.

3. Specification

4. Operation

4.1. Press On/Off to Operate (Refer to Figure 3)

• 4.1.1. First press: Low beam
• 4.1.2. Second press: High beam
• 4.1.3. Third press: switches on end torch
• 4.1.4. Fourth press: switches everything off.

4.2. Charging (Refer to Figure 2)

• 4.2.1. Open the cover on the side of the light.
• 4.2.2. Plug the USB-C cable into a 5V USB outlet.
• 4.2.3. Insert the Type-C connector into the charging port on the side.
• 4.2.4. For a full charge, the time is approximately 2 / 2.5hrs, depending on the model.

Diagram Description (Figure 2): Shows the inspection light from the side, highlighting the USB connection port, the magnet on the rear face, and the swivel foot with a magnetic base.

Diagram Description (Figure 3): Shows the inspection light from the rear, highlighting the ON/OFF button, the magnet on the rear face, and the rotatable foot.

5. Maintenance

• 5.1. Keep the light clean and check for damage before every use.
• 5.2. If damage is observed, remove from use until the unit is repaired.
• 5.3. The battery is not designed to be removed.
• 5.4. The battery fitted to this light is considered a consumable item and its ability to accept charge will reduce over time. Sealey warrants it against mechanical and electrical defects for a period of one year, which does not cover fair wear and tear. If the battery is not properly charged before first use, or regularly conditioned, its capacity will diminish. Under these circumstances, the battery will not be replaced even if it is less than one year old.

Environmental Protection

♻️ Recycle unwanted materials instead of disposing of them as waste. All tools, accessories, and packaging should be sorted, taken to a recycling centre, and disposed of in a manner compatible with the environment. When the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids according to local regulations.

WEEE Regulations

⚡ Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid waste authority for recycling information.

Battery Removal Information

? Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd is required to inform potential purchasers of products containing batteries (as defined within these regulations) that they are registered with Valpak's registered compliance scheme. Jack Sealey Ltd's Batteries Producer Registration Number (BPRN) is BPRN00705.