DALI SWITCH ON/OFF HDS2400
Installation and Instruction Manual
This on/off DALI controlled switch is ideally suited for retrofit where non-dimmable LED drivers, transformer or fluorescent ballasts have been used.
1. Product description
- DALI switch on/off
- Input: DALI, L, N
- Installation in box 60mm or stand alone installation.
2. Technical Specifications
- Product type
- DALI switch on/off
- Operating voltage
- 230/240VAC 50/60Hz
- Rated load
- 400W
- Power consumption
- ≤ 0.5W
- DALI power
- 2mA
- Operating temperature
- -20°C ~+50°C
- EMC standard
- EN55015
- DALI standard
- EN62386-101; 102; 205
3. Wiring Diagram
The wiring diagram illustrates the connection of the DALI HDS2400 switch within a DALI lighting system. It shows the mains power input (Live 'L' and Neutral 'N') and the DALI bus connections (DA, DA). The diagram depicts a typical setup where the switch is connected between the mains supply and the DALI bus, controlling DALI-compatible lighting fixtures. A 'Master' DALI controller is shown as part of the system.
The switch itself has clearly marked terminals for L, N, and the DALI bus (DA, DA).
Diagrams and Dimensions
Device Dimensions: The DALI HDS2400 switch has a primary body length of approximately 48.5mm and a width of 23mm. Further dimensions indicate an overall length of 77.1mm, a width of 51mm, and a height of 34.5mm.
Optional Accessory: An optional strain-relief clip is available for securing the cable connections.
Device View: A perspective view of the Hytronik HDS2400 DALI switch is provided, highlighting its compact design and connection terminals.
