AcuRite 00526W Thermometer Instruction Manual

Introduction

The AcuRite® Thermometer with wireless outdoor sensor collects outside weather data and sends it via wireless signal to the Display Unit. This thermometer is designed to be easy to install and use.

The display unit features a liquid crystal display (LCD) that calculates and displays temperature data received from the wireless sensor. It also includes a sensor for measuring indoor temperature and a character that displays clothing suggestions based on the current outdoor temperature. The Display Unit is powered by two "AA" alkaline batteries (not included).

The wireless outdoor sensor is completely wireless and contains a sensor for measuring outdoor temperature. It is powered by two "AA" alkaline or lithium batteries (not included).

Please read this manual thoroughly and keep it for future reference.

Parts List

Model #00526W

• Display Unit
• Wireless outdoor sensor

Overview: Display Features

The display shows:

• Outdoor Conditions: Current outdoor temperature reading.
• "How to Dress" Weather Character: Displays clothing recommendations based on the current outdoor temperature.
• Outdoor Temperature Alarm Display: Indicates if the outdoor temperature alarm is active.
• Indoor Temperature Display: Displays the current indoor temperature.

Setup: Battery Choice & Temperature Range

Extended periods of cold temperatures (below -4°F / -20°C) can cause alkaline batteries to function improperly, leading to the outdoor wireless sensor stopping temperature readings. Use lithium batteries in these low-temperature conditions to ensure continued operation.

Battery Compatibility:

• Lithium Batteries: -40°F to 158°F (-40°C to 70°C)
• Alkaline Batteries: -4°F to 158°F (-20°C to 70°C)

Battery Disposal: Please dispose of old or defective batteries in an environmentally safe way and in accordance with your local laws and regulations.

Battery Safety: Clean battery contacts and device contacts before installation. Remove batteries from equipment not in use for extended periods. Observe polarity (+/-) in the battery compartment. Promptly remove dead batteries. Dispose of used batteries properly. Use only equivalent or recommended battery types. Do not incinerate, dispose of in fire, mix old/new batteries or battery types, short-circuit terminals, recharge non-rechargeable batteries, or use rechargeable batteries.

Installing Batteries - Wireless Sensor

Remove the battery compartment cover. Install 2 fresh "AA" batteries as shown. Batteries must be installed for the sensor to operate.

Installing Batteries - Display Unit

Remove the battery compartment cover. Install 2 fresh "AA" batteries as shown.

Setup: Display Unit Preferences

This thermometer allows you to choose between °F or °C temperature display and select a boy or girl "how to dress" weather character.

To set preferences:

1. Press and hold the "SET" button to enter set mode. The temperature unit (°F or °C) will blink.
2. Use the "▲" or "▼" buttons to adjust the selected item.
3. Press "SET" again to save the adjustment and move to the next preference.

Preference Order:

• Temperature Scale (°F or °C)
• Boy or Girl Weather Character

Set mode will exit automatically after 30 seconds of inactivity.

Display Unit: MIN/MAX Memory

This forecaster records MINIMUM and MAXIMUM outdoor and indoor temperature/humidity readings.

• To view MIN values: Press and release the "▼" button. The "MIN" icon will appear. To clear MIN values, press and hold the "▼" button in MIN view mode. Dashes will appear to confirm clearing.
• To view MAX values: Press and release the "▲" button. The "MAX" icon will appear. To clear MAX values, press and hold the "▲" button in MAX view mode. Dashes will appear to confirm clearing.

Placement

Choose locations for the wireless sensor and display unit. The wireless sensor must be placed within 165 feet (50m) of the display unit.

This forecaster uses radio frequency for communication, which can be susceptible to interference from other electronic devices and large metallic items or thick walls. Place both units at least 3 feet (.91 m) away from appliances (TV, microwave, radios, etc.) or objects that may interfere with wireless communication (large metal surfaces, thick stone walls, etc.).

Placement of Display Unit: Place the display unit in a dry area free of dirt and dust. To ensure accurate indoor temperature measurement, place it out of direct sunlight and away from heat sources or vents. Options include hanging on a wall using the integrated hang hole or placing on a flat surface using the table top display stand.

Placement of Sensor: The wireless sensor MUST be placed OUTDOORS to measure outdoor temperatures. It must be within 165 feet (50 m) of the display unit. The sensor is water-resistant for general outdoor use, but to extend its life, place it in an area protected from direct weather elements. For accurate outdoor temperature measurement, place it out of direct sunlight and away from heat sources. Options include hanging using one of the two integrated hang holes or using string to hang from a suitable location like a well-covered tree branch.

Use: "How to Dress" Character

This thermometer features an icon that automatically suggests clothing recommendations based on the current outdoor temperature.

Temperature Scale (°F / °C): The display shows temperature in Fahrenheit (°F) or Celsius (°C).

Indoor Temperature: The indoor temperature display uses the same area as the alarm value display. It is shown only when the alarm is OFF.

Outdoor Temperature Alarm:

• To turn on the alarm, press the "▼" button below the display. The default alarm value of 32°F will be shown. The alarm will sound if the outdoor temperature reaches 32°F.
• To change the alarm temperature, press and HOLD the "▼" button. The alarm value will flash. Use the "▲" or "▼" buttons to adjust the alarm value.
• When an alarm sounds, press the "ALARM STOP" button on top of the display to silence it. The alarm will sound again if the alarm temperature is reached again. To prevent the alarm from sounding, turn it off by pressing the "▼" button.

Temperature Alarm Note:

• If the set alarm value is below 50°F, the alarm sounds only if the temperature has FALLEN below the set value.
• If the set alarm value is above 50°F, the alarm sounds only if the temperature has RISEN above the set value.

Troubleshooting

Specifications

Product Facts:

• Batteries: 4 x "AA" (not included)
• Lithium Batteries Recommended in Outdoor Sensor if temperatures are below -4°F.

Measurement Ranges:

• Outdoor Temperature: -40°F to 158°F (-40°C to 70°C)
• Indoor Temperature: 32°F to 122°F (0°C to 50°C)

Wireless Range: 165 ft / 50 m MAX (Depending on home construction materials)

Manufacturer Information:

• Made in China
• Limited One Year Warranty
• Instructions & Warranty Enclosed
• Customer Care: 877-221-1252
• Website: www.chaneyinstrument.com

Patent Numbers: 5,978,738; 6,076,044; 6,597,990

ACURITE® is a registered trademark of the Chaney Instrument Co., Lake Geneva, WI.

Customer Support: Please do not return the product to the retail store. For technical assistance and product return information, please call Customer Care at 877-221-1252, Monday - Friday, 8:00 A.M. to 4:30 P.M. (CST). Visit www.chaneyinstrument.com.

Product Registration

To receive product updates and information, log on to www.chaneyinstrument.com.