AUVON AS8012C TENS Massager User Manual

In This Standard Package

• AUVON TENS dual-channel massager
• Electrode pads
• Electrode pad holder
• Bag
• Lead wire set (1/2 Wire)
• USB cable and USB adapter
• User Manual
• Happy Card

Features

• 2 outputs with 24 modes
• 20 intensity levels
• Preset timer of 20 minutes, adjustable from 10 to 90 minutes.
• Rechargeable lithium battery
• Battery indicator to know when to recharge
• AC adapter 110-240V, USB charger 5V

Safety Precautions and Warnings

DO NOT USE IN THESE CONDITIONS

Consult your doctor before using this unit.

The unit may cause lethal rhythm disturbances in certain susceptible individuals. If you have had a recent surgical procedure, the stimulation may interrupt the healing process.

Before using your unit, inspect these items:

1. The cord is not broken.
2. The pad gel is not damaged.
3. The electrode cable connection is not broken.
4. The unit is intact and functioning.
5. There is no battery leakage.

DO NOT APPLY THE PRODUCT TO THESE PERSONS

• Pregnant women.
• Do not use on children or infants as the device has not been evaluated for pediatric use.
• Keep out of reach of small children as the electrode cable could cause strangulation.
• Persons unable to express their thoughts or intentions.
• Persons unable to operate the unit by themselves.
• Use with caution if you have a tendency to bleed internally, such as after an injury or fracture.
• If you suspect or are diagnosed with a heart condition, you must follow the precautions recommended by your doctor.
• If you have a suspected or actual epilepsy, you must follow the precautions recommended by your doctor.
• Be careful if stimulation is applied over the menstrual uterus.

NEVER APPLY THE ELECTRODES TO THESE AREAS OF THE BODY:

• The head, mouth, or any area of the face.
• The neck or any area of the throat, as this could cause severe muscle spasms resulting in airway closure, difficulty breathing, or adverse effects on heart rhythm or blood pressure.
• Do not use near the heart or in the genital area.
• Both sides of the chest simultaneously (lateral or front and back), or across the chest because the electrical current may cause rhythm disturbances that could be lethal.
• Both calves at the same time, as this can cause a cardiac disturbance.
• The lower part of both feet at the same time, as this can cause a cardiac disturbance. Open wounds or rashes or inflamed areas, red, infected or inflamed areas, or skin eruptions (such as varicose veins, phlebitis, thrombophlebitis, and thrombosis), or on or near cancerous lesions, or on areas of skin that lack normal sensation.

DO NOT USE THIS UNIT DURING THESE ACTIVITIES

• When in the bathtub or shower;
• While sleeping;
• While driving, operating machinery, or during any activity where electrical stimulation could put you at risk of injury.

WARNINGS FOR PAIN TREATMENT

• If you have received medical or physical treatment for your pain, consult with your doctor before using this unit.
• If your pain does not improve, becomes chronic or severe, or continues for more than five years, discontinue use of the unit and consult your doctor.
• The mere existence of pain serves as a very important warning that something is wrong. Therefore, if you suffer from any serious illness, consult your doctor to confirm that it is advisable to use this pain relief unit.

Pad Precautions

• Do not move the pads to another location while the unit is on.
• The therapy will not work with a single pad. You must use two pads at the same time.
• Ensure that the components are properly connected and the pads are fixed to the body part you wish to treat, or the therapy may not be effective.
• The pad should not touch any metal object, such as a belt buckle, necklace, or other metal worn under clothing.
• Do not overlap the pads or place one pad on top of another. This can weaken or stop the therapy, or the unit may stop working. Gel pads can also stick together, causing the gel to be removed when separated.
• Do not share the pads with another person. This can cause skin irritation or infection. Pads are intended for use by one person.
• Do not leave the pads attached to the skin after treatment.
• Do not bend or fold them, as the gel may be damaged and they will not stick or work correctly.
• To avoid damaging the adhesive surface of the pads, place the pads only on the skin or on the provided plastic pad holder to prevent damage to the adhesive surface of the pads.
• Always place clean pads according to the provided illustrations.
• Do not apply ointment or any solvent to the pads or your skin, as it will interfere with their operation. The adhesive pads will adhere to your skin.

How It Works

Scientific theory suggests that electrical stimulation therapy can work in several ways:

1. The gentle electrical pulse travels through the skin to the nerves to block or turn off the pain message from the source of pain to the brain.
2. The gentle electrical pulse increases the body's natural painkiller production, such as endorphins.
3. Furthermore, it is believed that electrical stimulation also improves blood circulation. Muscles contract and relax with the flow of electrical stimulation. With contraction and relaxation, blood flows in and out, and blood circulation improves.

Operating Instructions

HOW TO USE

1. Clean your skin before use. Use the pads on clean, flat areas, free of sweat and grease.
2. Attach one or two pairs of electrode pads to the area of the massager, such as the shoulder and leg.
   Note: Adding a few drops of water to the pads and drying them naturally will increase their longevity. Ensure both pads are on the skin and do not overlap.
3. Connect a pair of electrode pads to a lead wire by plugging them in; the other end of the wire connects to the left output of the device. Similarly, connect the other pair of electrode pads to the remaining wire end and to the right output of the device.
4. Turn on the device by sliding the power switch on the top of the unit.
5. Press the left "V" or "Λ" to select channel A, then "A" will start to flash. (Or press the right "V" or "Λ" to select channel B, and then "B" will start to flash.)
6. Press the "V" or "Λ" button to select 6 master modes, and press the "V" or "Λ" button to select sub-modes. If "A" is flashing, the selected mode is for channel A. (If "B" is flashing, the selected mode is for channel B).
7. Press the left "V" or "Λ" to increase or decrease the intensity for channel A. Press the right "V" or "Λ" to increase or decrease the intensity for channel B.
   Note: Remember that the intensity will default to the lowest value for each mode selection.
8. The recommended application is from 10 to 90 minutes. Increase by 10 minutes for each adjustment by pressing the "T" on the device. The remaining time counts down automatically until the unit turns off once the time is up.
9. Press and hold the center button for 3 seconds to lock the screen, press again for 3 seconds to unlock.

AFTER USE

1. Turn off the device by sliding the power/off switch on the top of the unit.
2. Remove the electrode cable plug from the connector by gently twisting and pulling it out.
3. Lift a corner of the electrode and slowly peel it off. Avoid touching the gel as much as possible. Do not pull the electrode by the cable.
4. Remove the electrodes from the storage bag and close it tightly again to prevent them from drying out. Store at room temperature or cool and keep away from direct sunlight.

Recommended Massage Points

Diagrams show electrode placement on various body parts: lower back, arm, thigh, knee, calf, ankle, elbow, upper back, and abdomen.

Device Illustrations and Accessories

1. Power Switch: ON/OFF toggle.

2. USB Port: For charging the device.

3. Timer Display: Shows remaining treatment time.

4. Battery Indicator: Shows battery level.

5. Intensity Adjustment (Channel A): Increase/decrease intensity for Channel A.

6. Intensity Adjustment (Channel B): Increase/decrease intensity for Channel B.

7. Lock: Screen lock/unlock button.

8. Intensity Increase (Channel A): Button to increase intensity for Channel A.

9. Intensity Decrease (Channel A): Button to decrease intensity for Channel A.

10. Timer Selection: Button to adjust treatment time.

11. Mode Selection: Button to select master modes.

12. Sub-mode Selection: Buttons ("<" and ">") to select sub-modes.

13. Intensity Increase (Channel B): Button to increase intensity for Channel B.

14. Intensity Decrease (Channel B): Button to decrease intensity for Channel B.

15. Output Connectors: Two ports for electrode cables.

Program Details

Troubleshooting

Pad Holder

The AUVON TENS massager has 6 massage modes and 24 sub-modes to choose from.

Features

High-quality ABS material to ensure safe use.

Wide compatibility for different sizes of electrode pads.

The protruding tip shape is specially designed to reduce damage to the pads.

Instructions

Step 1

Attach the electrode pads to the holder to prevent dust accumulation.

Step 2

Wrap the wire around the holder for easy use as shown in the image.

Maintenance and Care

1. When finished using the device, turn it off and remove the pads. Store the unit in a cool, dry place until the next use.
2. After use, please cover the pads with the protective film and place them back into their ziploc bags. Applying a few drops of water before and after use will increase the longevity of the pads. Alternatively, attach the electrode pads to the holder and wrap the wire around the holder.
3. Charge the unit at least every 3 months if it is not used regularly. You can also use the unit with a wall charger or directly from a computer via the USB cable.

Warning

1. The stimulator has no output when charging. You must remove the electrode pads from your body before the stimulator charges.
2. Charge only with this AC adapter (Model: GDP06AV-0500550-UL, Manufacturer: Shenzhen Guandexin Technology Co., Ltd.).

Environmental Operation for the Adapter

Charger Specifications

• Input: 100-240V 50/60Hz 0.18A Max
• Output: DC5V---250mA
• Class II, not applicable part, not suitable for use in the presence of a flammable anesthetic mixture with air or with oxygen or nitrous oxide, continuous operation.

The combination of the stimulator and the AC adapter is considered a medical electrical system. The AC adapter is not considered part of the ME system of the ME equipment.

Charging the Battery

1. Turn off the controller.
2. Connect the controller and charger with the USB extension cable. Plug the charger into any power outlet; the green light indicates charging. The charging process will take approximately 1 hour.

Note: Only charge the controller when the battery is completely depleted for the first 2 times. Unplug the charger from the power outlet when charging is complete. When the massage strength decreases, it indicates that the device needs charging. Recharge it and then continue using the device. Do not use the controller while charging.

Technical Specifications

Customer Service

• Limited warranty of 24 months
• Warranty extension for lifetime technical support: Register at https://www.iauvon.com/register, you may get 36 months of free warranty.
• Phone: +1 (678) 829-7256
• Email: support@iauvon.com
• Website: https://www.iauvon.com