Philips Bustan Outdoor Light Installation Guide

Introduction

This guide provides instructions for the installation of the Philips Bustan outdoor lighting fixture.

The following languages are supported in this manual:

• English (User manual)
• German (Benutzerhandbuch)
• French (Notice d'emploi)
• Spanish (Manual de usuario)
• Portuguese (Manual do usuário)
• Italian (Manuale d'uso)
• Dutch (Gebruiksaanwijzing)

Included and Required Items

Included [A]

• Main light fixture components
• Mounting bracket/base

Required Tools and Materials [B]

• [Drill]
• [Screws]
• [Wall anchors]
• [Pencil]
• [Utility knife]
• [Phillips screwdriver]
• [Flathead screwdriver]

Product Specifications and Safety

• IP44 rated: Protected against solid objects >1mm and water splashes from any direction.
• Input Voltage: 230V
• Energy Efficiency Class: F ([energy efficiency class F])
• Connection to mains power indicated by [light switch] symbol.
• Specific connection size indicated by [pipe fitting] symbol (3/8" 8mm).
• [No direct connection] symbol indicates wiring precautions.
• [Dimmer control] symbol indicates compatibility or requirement.
• [Cable protection] symbol indicates cable handling.
• [Cable clamp] symbol indicates securing cables.
• [LED indicator] symbols show light source type.
• [User] symbols indicate user interaction.

Installation Steps

1. Step 1: Electrical Safety

   Ensure the power supply is turned OFF at the main circuit breaker before starting installation. [Circuit breaker] symbol shown with hand turning switch to OFF.

2. Step 2: Prepare Mounting Location

   Mark the mounting points on the wall or ground using a [pencil]. Drill holes and insert [wall anchors] if necessary. Secure the mounting bracket/base using [screws]. The material is described as Inox / Stainless Steel.

3. Step 3: Attach Fixture Body to Base

   Align the main fixture body with the base and secure it using screws. [Screwdriver] and [rotate] symbols indicate the action.

4. Step 4: Open Fixture Housing

   Carefully open the main housing of the light fixture to access the internal components. [Arrow] symbol indicates direction.

5. Step 5: Access Wiring Compartment

   Remove the internal compartment cover to expose the wiring terminals and internal components. [Arrow] symbol indicates direction.

6. Step 6: Prepare Wires

   Strip the ends of the power supply wires and the fixture wires as needed. Use appropriate tools like wire strippers and [screwdrivers] for terminal blocks.

7. Step 7: Connect Wires

   Connect the power supply wires (Live, Neutral, Earth) to the corresponding terminals within the fixture. Ensure secure connections using the terminal block. [Close-up of terminal block] shown.

8. Step 8: Close Fixture Housing

   Replace the internal compartment cover and then the main fixture housing. [Arrow] symbols indicate closing direction.

9. Step 9: Secure Fixture

   Secure the fixture housing with screws. [Screwdriver] and [rotate] symbols indicate the action.

10. Step 10: Attach Top Cover

    Attach the top cover or diffuser to the fixture. [Arrow] symbol indicates direction.

11. Step 11: Final Mounting

    If the fixture is mounted to a post or wall, ensure it is securely fastened using the provided hardware. [Screwdriver] and [rotate] symbols indicate the action.

12. Step 12: Restore Power

    Turn the power supply back ON at the main circuit breaker. [Circuit breaker] symbol shown with hand turning switch to ON.