Philips Bustan Outdoor LED Light with Motion Sensor

Included Components

• A: User Manual
• B: User Manual

The product itself is depicted as a rectangular outdoor light fixture with a motion sensor in the center. It is designed for wall mounting.

Tools and Materials Required (Excluding)

• Drill
• Screwdriver (Phillips and flathead)
• Pencil
• Utility knife
• Wall plugs and screws (for mounting)

Product Specifications and Features

• IP Rating: IP44 (protected against solid objects >1mm and water splashes from any direction)
• Grounding: Symbol indicates grounding is required.
• Connection Size: 3/8" (8mm)
• Detection Range: Maximum 4 meters
• Detection Angle: 110°
• Light Sensitivity Adjustment: Time delay can be set from a minimum of 2 seconds to a maximum of 12 minutes.
• Light Output: LED
• Energy Efficiency Class: F

Installation Instructions

1. Preparation: Ensure the power is turned OFF at the main circuit breaker.
2. Mounting Bracket: Attach the mounting bracket to the wall using appropriate screws and wall plugs. The diagram shows the bracket being secured to a wall. The material is specified as Inox / Stainless Steel / Inoxydable / Edelstahl / Roestvrij Staal / Acero Inoxidable.
3. Wiring: Connect the wires according to the diagram. Typically, this involves connecting the Live (L), Neutral (N), and Ground wires to the corresponding terminals within the light fixture. The diagram shows a terminal block with L, N, and Ground connections.
4. Attaching the Fixture: Secure the light fixture to the mounting bracket. The diagram shows the fixture being slid onto the bracket and then secured with screws.
5. Power On: Turn the power back ON at the main circuit breaker.

Operation and Settings

• Motion Sensor Adjustment: The sensor can be adjusted for sensitivity and time delay.
• Time Delay: The duration the light stays on after motion is detected can be adjusted (MIN 2 SEC to MAX 12 MIN).
• Light Sensitivity (Lux): The ambient light level at which the sensor activates can be adjusted.
• Testing: The diagram shows a test mode where the light turns on for a short period (approximately 30 seconds) regardless of ambient light.

Troubleshooting

Refer to the detailed user manual for troubleshooting specific issues.