Corston

Included Items

• Switch module x1
• Plastic cover x1
• Brass cover x1
• Pull handle, cord connector & cord x1
• 4mm wood screw x2
• Wall plug x2

Tools You'll Need

• Drill
• 2mm drill bit (for surfaces that don't require wall plugs)
• 4mm drill bit (for surfaces that require wall plugs)
• Crosshead screwdriver

Installation Instructions

1. Remove the brass and plastic covers. Remove conduit covers as required.

2. Mark and drill holes where the module will be. If using wall plugs, drill 5mm holes; otherwise, drill 2mm pilot holes.

3. If applicable, insert the wall plugs into the holes.

4. Pull through wiring and screw the module to the ceiling.

5. Screw wiring into the correct terminations.

6. Screw the plastic cover onto the module, then thread the brass cover over the top.

7. Use the cord connector to adjust the length of the cord as desired.