To install, isolate the power supply at the consumer unit circuit breaker and verify that the power is off. These products must be installed by a qualified electrician in accordance with the latest building regulations.
Features
- 15 second power-off delay
- Rated to 16A
- Built-in short circuit protection
- Supply voltage 220V-240V ~ 50Hz
- Complies with IEC EN60669
Warning & Installation Information
Electric shock hazard. Hazardous voltage may be present at the output of the module. Ensure the input circuit is identified and isolated before accessing wiring connections. Failure to follow this warning can result in death or serious injury.
The module should be protected by a circuit breaker rated up to 16A maximum.
Dimensions
Diagram illustrating the hotel key card switch module's physical characteristics. The top view shows the module's overall shape, typically rectangular with rounded corners, indicating mounting points. The side view depicts the module installed within a wall cutout, specifying key dimensions: 13.6mm for the depth of the module's faceplate and 32.4mm for the total depth of the module body.
One-Way Wiring Diagram
The diagram outlines a standard single-pole switching circuit configuration. Incoming live (L) and neutral (N) wires are connected to the "Hotel key card switch" module. The module's output, typically a switched live (L1), is then routed to a "Switch" component. This switch controls the power supply to a light bulb. The neutral wire is also connected directly to the light bulb.
[CE mark]
Email: hi@corston.eu | Phone: +44 (0)1249 549332
Document Reference: N-0035-EN-EU_r0
