Philips Dynalite PAxBPE AntumbraButton User Interface
Installation Instructions
Safety and Electrical Requirements
Devices must be installed by a qualified electrician in accordance with all national and local electrical and construction codes and regulations. The installation of a home and building automation and control system shall comply with HD 60364-4-41. The temperature limits and current-carrying capacities for the communication wires specified in HD 384.5.523 shall not be exceeded.
This product is designed for use with SELV/Class 2 (UL) circuits and conforms to IEC Overvoltage Category III.
Important Warnings:
- Do not connect inputs to mains. ?
- Disconnect power before connecting or separating modules. ?
Product Dimensions and Mounting
The PAxBPE AntumbraButton User Interface has the following dimensions:
- Width: 60 mm (2.36 in)
- Height: 88 mm (3.46 in)
- Depth: 36 mm (1.41 in)
Mounting requires minimum clearances of 300 mm (11.81 in) from other devices or obstructions in all directions (A and B). The unit is designed to be mounted within a standard wall box.
Diagram Description: The diagrams illustrate the unit's dimensions and how it fits into a wall mounting system, showing the front plate and the internal components.
Wiring and Connections
Wiring specifications:
- Wire Gauge: 0.3-2.5mm² (22-12 AWG)
- Terminal Torque: 0.4 Nm (3.5 Lb-in) for smaller terminals, 1.0 Nm (8.8 Lb-in) for larger terminals.
The unit supports RS-485 DyNet communication. The DyNet interface operates with 12 V at 35 mA or 24 V at 20 mA.
The maximum current rating for the unit is ≤ 2 A.
Diagram Description: The wiring diagram shows the connection terminals labeled +V, D-, D+, GND, SHLD, and RS-485 DyNet. It illustrates how to connect the communication cables, including the shield.
Environmental and Compliance Information
Operating conditions:
- Temperature: -5° C (23° F) to 50° C (122° F) ?️
- Humidity: ≤ 90% ?
Compliance Marks:
- CE (✅)
- UKCA (??)
- C-Tick (??)
- FCC (??)
Federal Communications Commission (FCC) Compliance Notice: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. If this equipment causes harmful interference to radio or television reception, users are encouraged to try to correct the interference by reorienting or relocating the receiving antenna, increasing the separation between the equipment and receiver, or connecting the equipment to an outlet on a circuit different from that to which the receiver is connected. Modifications not approved by the manufacturer may void the user's authority to operate the device.
This Class B digital apparatus complies with Canadian ICES-003: CAN ICES-3(B)/NMB-3(B).
