Step 1: Identify Components
Step 2: Remove Bottom Screws
Remove the four screws from the bottom of the reComputer Industrial.
Step 3: Remove Side Panels
Remove the two side panels from the reComputer Industrial.
Step 4: Remove Rear Case
Remove the rear case of the reComputer Industrial.
Step 5: Remove Carrier Board Screws
Remove the four fixing screws securing the carrier board.
Step 6: Install/Replace Modules
SSD Installation/Replacement
If you need to replace the SSD, remove the screws and gently remove the SSD module.
Mini PCIE Module Installation
For module installation:
- LoRaWAN® Module: Insert the LoRaWAN® module into the Mini PCIE interface (lower interface) and lock it with two screws (diagram shows 4x2 screws).
- 4G/5G Module: Insert the 4G/5G module into the M.2 Key B interface (upper interface) and lock it with one screw (diagram shows 5x1 screws).
Note: Only one module can be installed at a time on these two interfaces.
Step 7: Install Carrier Board
Install the carrier board and lock it with four screws.
Step 8: Install Rear Case
Install the rear case.
Step 9: Install Side Panels
Install the two side panels.
Step 10: Secure Assembly
Lock the assembly with four screws.
Step 11: Final Check
Ensure all components are securely fastened.
