EK-Quantum Surface X-Flow Radiator Setup Configurations

Important Information

Please note that the installation of the product is intended to be undertaken by an adequately trained and experienced person. You are installing the product at your own risk. If you are not properly trained or experienced or feel unsure about the installation procedure, please refrain from installing the product yourself and contact EKWB tech support for assistance. EKWB disclaims liability for any damages to the product as well as incidental, consequential, or indirect damages incurred due to improper or inappropriate installation.

Before you start using this product, please follow these basic guidelines:

• Carefully read the manual before beginning with the installation process.
• EK Fittings require only a small amount of force to screw them firmly in place since the liquid seal is ensured with the rubber O-ring gaskets.
• The use of quality market-proven corrosion-inhibiting coolants is always strongly recommended for any liquid cooling system.
• Do not use pure distilled water as a cooling liquid! For best results, EKWB recommends the use of EK-CryoFuel Coolants.

EK-Quantum Surface X-Flow Radiator Setup Configurations

Please note that the X-flow radiators do not have a classical U-shape coolant flow (inlet and outlet only on one side of the radiator) but rather in crossflow (inlet on one side, outlet on the other side). Crossflow port setup on the X-Flow Radiator is mandatory! However, you can choose the direction of the crossflow in your custom loop.

Crossflow Configuration 1

On the picture, you can see the first crossflow configuration. You have to choose at least one of the ports on each side of the radiator to be an inlet and an outlet.

Diagram Description: An illustration of the EK-Quantum Surface P360M X-Flow radiator showing inlet and outlet options on opposite sides. Arrows indicate coolant flow entering from one side and exiting from the other.

Configuration Label: CONFIG 1

Crossflow Configuration 2

On the picture, you can see the second crossflow configuration. You have to choose at least one of the ports on each side of the radiator to be an inlet and an outlet.

Diagram Description: An illustration of the EK-Quantum Surface P360M X-Flow radiator showing inlet and outlet options on opposite sides, similar to Configuration 1 but with a different port selection indicated by arrows.

Configuration Label: CONFIG 2

Important Notes:

• ℹ It is mandatory to use the extenders on any inlet and outlet position!
• ℹ If transferred from the stock position of the radiator to another, check if the extenders are tightened to avoid leakage!
• ℹ EKWB recommends using the same number of inlets and outlets for the most optimal performance.
• ℹ The same crossflow port setup configurations applies for all EK-Quantum Surface X-Flow radiator variants!

Exploded View of Removable Components

Diagram Description: An exploded view of the EK-Quantum Surface P360M X-Flow radiator, showing all its individual components. Labeled parts include: 2x QUANTUM SURFACE END TANK SHROUD (ALUMINIUM), 2x QUANTUM SURFACE EXTENDER, EK-Quantum Surface P360M X-Flow (main unit), QUANTUM SURFACE TANK, 2x QUANTUM SURFACE SIDE PLATE (STAINLESS STEEL), 6x QUANTUM SURFACE PLUG, and 8x TORX SCREW M3 x 6 mm.

Support and Service

In case you need assistance, please contact:

https://www.ekwb.com/customer-support/

EKWB d.o.o.
Pod lipami 18
1218 Komenda
Slovenia - EU

Social Media

• f EKWaterBlocks
• @ EKWaterBlocks
• ✉️ ekwaterblocks
• ▶️ EKWBofficial
• p ekwaterblocks