Artika Skyview Ultra Slim LED Recessed Downlight Panel

Included Hardware

Step-by-Step Installation

1A: Preinstall Cut Ceiling Hole

Cut a hole in the ceiling with either a hand saw or a hole saw (4 3/8" - 110 mm). [Diagram shows a hand saw and a hole saw being used to cut a circular hole in a ceiling.]

1B: Preinstall Break Knock-out

Break the knock-out with the help of a tool. [Diagram shows a screwdriver being used to break a pre-scored section on a metal box.]

2A: Wires Connection (No Dimmer)

CAUTION: Do not use these wires unless a 0-10V dimmer is connected. [Diagram shows wiring connections inside a power box. Wires are labeled: Purple/Violet, Pink/Rose, Black (L), White (N), and Ground wire (GND). Wire connectors (C and D) are shown.]

2B: Wires Connection (0-10V Dimmer)

[Diagram shows wiring connections for a 0-10V dimmer switch and the power box. Wires are labeled: Purple/Violet, Pink/Rose, Black (L), White (N), and Ground wire (GND). Wire connectors (C and D) are shown.]

3: Fixture Connection

[Diagram shows the power box (B) and the fixture (A) with their connecting cables.]

4: Selectable White Technology

[Diagram shows a close-up of a switch on the fixture's driver, with options: 2700K, 3000K, 3500K, 4000K, 5000K.]

5: Feed Power Box Through Hole

[Diagram shows the power box being fed upwards through the ceiling hole.]

6: Feed Fixture Through Hole

[Diagram shows the fixture being fed upwards through the ceiling hole, with two steps indicated: 1. Securing the fixture clips, 2. Pushing the fixture up.]

7: Final Install

[Diagram shows the fixture fully installed in the ceiling, with a "CLICK" sound indicated, suggesting it has locked into place.]

Safety Information & Warnings

WARNING: Risk of electrical shock. Turn off breaker at the panel. Switch off the main electrical supply from the fuse box/circuit breaker before installing the unit or doing any maintenance. Do not use outdoor.

CAUTION: If using a dimmer, it must be LED compatible.

IMPORTANT: The installer and/or user must read, understand, and follow these instructions before installing the product. This product must be properly installed before it is used. Failure to follow instructions may result in product malfunction, and the manufacturer will not be held responsible. Failure to follow installation and/or operating instructions voids the warranty. It is recommended that this product be installed by a certified electrician, as required by local electrical and building codes.

FCC Compliance (USA)

WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device does not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception. However, there is no guarantee that interference will not occur in a particular installation. If this equipment causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Warranty

Artika For Living Inc. offers a five-year (5) limited warranty on manufacturing defects for residential use only, from the date of purchase. This warranty extends to the original owner in the USA, Canada, Mexico, UK, Iceland, France, and Spain and is non-transferable. It does not apply to retailers, commercial applications, or establishments. The original sales receipt is required for all warranty claims. The remedy is product or part replacement at Artika's discretion, not exceeding the original purchase price.

This warranty is valid only for products installed in accordance with the building code and laws effective in the region, and the provided instruction manual. It does not cover products installed incorrectly, subjected to abnormal use, or damage from normal wear and tear, misuse, negligence, vandalism, improper maintenance, accidents, abuse, fire, flood, theft, acts of God, or alterations. Accessories like bulbs or batteries are excluded. The warranty does not cover handling, labor, transportation, or other costs associated with installation or replacement.

Artika For Living Inc. will not be held responsible for any direct or consequential damages or injuries related to improper use or installation of this product.

For more information, please visit www.artika.com.

Contact Information

Artika For Living Inc.
800, Boulevard Hymus
Saint-Laurent (Québec) H4S 0B5
Canada

Phone: 1-866-661-9606
Email: support@artika.com
Website: www.artika.com

Customer Service: Monday to Friday, 9 am - 5 pm EST. Service is provided in English, French, and Spanish.