Eufy WetVac W31 Quick Start Guide

Quick Tips

1. Step 1: Assemble Handle

   Insert the handle bar into the main body. You will hear a click when the handle bar is locked in place.

2. Step 2: Fill Clean Water Tank

   Remove the clean water tank, open the rubber cover, and add water. Note: Use 2 bottle caps of floor cleaner for best results.

3. Step 3: Replace Clean Water Tank

   Replace the clean water tank. You will hear a click when the water tank is locked in place.

4. Step 4: Prepare to Clean

   Gently step on the foot pedal and push the handle bar backward until you hear a click.

5. Step 5: Start Cleaning

   Press the Power button to start cleaning. Press the speed control button to select a rotation speed: High / Low. Press the water spray button. Water and floor cleaner will spray onto the rolling brush.

6. Step 6: Finish Cleaning

   Press the power button or push the handle bar forward until you hear a click. The vacuum automatically turns off. Note: After you press the power button, it will take 5 seconds for the vacuum to stop cleaning.

Cleaning and Maintenance

1. Step 1: Remove Dirty Water Tank

   Remove the dirty water tank after use. Press the release button to remove the dirty water tank.

2. Step 2: Clean Dirty Water Tank

   Clean the dirty water tank. Rinse the dirty water tank thoroughly with water.

3. Step 3: Replace Dirty Water Tank

   Replace the dirty water tank. After cleaning, reinstall and replace the dirty water tank by tilting it backward at a 45° angle.

Self-cleaning

Place the vacuum on its charging base to charge and press the self-cleaning button. The process takes approximately 3 minutes. Do not move the vacuum during self-cleaning.

Notes

When the "Cleaning" indicator for the dirty water tank lights up red, check if the filter and dirty water tank are dirty. Wash and air dry them before reuse.

This quick start guide is for routine cleaning. You can find detailed instructions in the user manual.