Baby Trend Venture LX Stroller

Important Safety Information

Read all instructions BEFORE assembly and USE of product. KEEP INSTRUCTIONS FOR FUTURE USE.

WARNINGS:

• Follow all instructions to ensure child safety.
• Failure to follow instructions could result in serious injury or death.
• Always use the safety harness and ensure children are properly positioned.
• Never leave children unattended.
• This stroller is designed for one child only.
• Do not allow children to use the stroller as a toy.
• Never use on stairways or escalators.
• Never use with roller skates, in-line skates, skateboards, or bicycles.
• Be aware that purses, shopping bags, parcels, diaper bags, or accessory items can change the stroller's balance, creating a hazardous condition.

Weight Limits:

• Storage Basket: 5 lbs (2.27 kg)
• Parent Tray & Child Tray: 3 lbs (1.36 kg) each
• Maximum Child Weight: 40 lbs (18.14 kg) or 40 inches

General Precautions:

• Ensure the stroller is fully opened and locked before allowing a child near it.
• Excessive weight can cause hazardous unstable conditions.
• Check regularly for loose screws, worn parts, torn material, or stitching. Replace or repair parts as needed.
• Discontinue use if the stroller malfunctions or is damaged. Contact customer service for repair or replacement parts.

Customer Service Note: If experiencing difficulties with assembly, missing parts, or use, do not return to the store. Contact Baby Trend Customer Service directly.

Parts Identification

Ensure all parts are present before assembly:

• Stroller (Carrito / Poussette)
• Child Tray (Bandeja para niños / Plateau pour enfant)
• Parent Tray (Bandeja para padres / Plateau pour adulte)
• Front Wheel (Rueda delantera / Roue avant)
• Rear Axle (Eje trasero / Essieu arrière)
• Infant Car Seat (Optional) (Sillita para el automóvil / Siège d'auto pour bébé)

Note: Infant car seats may come with a stay-in-car base. Refer to the infant car seat manual for base type and instructions.

Assembly Instructions

Adult assembly is required.

General Assembly: Remove stroller from box. Front wheels, rear wheels, child tray, and parent tray must be installed prior to use.

Front Wheels

To attach front wheels:

• Unlock the release lever.
• Unfold the stroller frame by pulling backward on the handle.
• Lean the stroller back so it rests on the handle with legs pointing upward.
• Position front wheels over the front leg tubes, aligning the hole. Push firmly down until wheels lock securely. Tug to ensure attachment.

Rear Wheels

To attach rear axle and wheels:

• Position the axle assembly over the rear leg tubes with brake pedals facing the back.
• Push down evenly on both sides until they lock into place.

Note: Never use the stroller if wheels do not lock into place.

Child Tray

To attach the child tray:

• Push the angled side of the tray onto the post at the right armrest while pressing the snap button downward until it locks.
• Rotate the tray downward until it latches onto the left armrest.
• Ensure the snap button is securely in place.

To remove the child tray: Press the snap button on the right side and pull forward until released.

Parent Tray

To attach the parent tray:

• Line up the tray slots with corresponding stroller frame slots.
• Slide down until locking into place. Ensure it is secure before use.

WARNING: Do not place hot liquids or more than 3 lbs in the parent tray. Serious burns or unstable conditions could result.

Canopy

To install the canopy:

• Slide the male ends of the canopy into the female slots on the stroller frame.

To open the canopy: Push forward on the front edge while holding the rear in place. To fold: Pull backward on the front edge.

Drop Down Basket

To install the rear basket tube:

• Insert the female end of the rear basket tube into the male ends on the basket frame until it locks.
• The basket is ready for use. Push down on the tube to access the basket, then release.

Infant Car Seat Attachment

WARNING: Failure to follow these car seat attachment instructions could result in serious injury or death.

To attach the infant car seat:

• Adjust the seat back to its most upright position.
• Ensure the front child tray is firmly attached.
• Position the infant car seat facing the rear of the stroller, with the seat shell fitting into the front tray and latching.
• Secure the infant car seat with the short clip, feeding it through the seat belt slot on the car seat. IT IS VERY IMPORTANT THAT THE SHORT CLIP IS ALWAYS TIGHTLY FASTENED AROUND THE INFANT CAR SEAT.

To remove the Infant Car Seat: Squeeze the release handle at the foot-end of the seat and lift upward.

Folding and Unfolding

CAUTION: Read this section completely before folding.

WARNING: Be careful when folding/unfolding to prevent finger entrapment.

To Fold Stroller:

• Close the canopy.
• Place the seat in the furthest recline position.
• Pull stroller backward to rotate front wheels forward.
• Slide the RED thumb trigger to the left and squeeze the RED pull trigger while pushing forward on the handle.
• Once folding begins, release the handle and push forward until folded. Lock the red release lever.

To Unfold Stroller:

• Unlock the release lever.
• Unfold the stroller frame by pulling backward on the handle.

Safety Features & Usage

Brakes

WARNING: Always set brakes when the stroller is not being pushed to prevent rolling away. Never leave unattended on a hill or incline.

To engage brakes: Apply light downward pressure to the brake lever on each rear wheel. You may need to move the stroller slightly forward or backward to align the brake teeth. Check that the stroller will not move and both brakes are applied. To release, gently lift the brake lever.

Child Harness

WARNING: Avoid serious injury from falling or sliding out. Always use the safety harness.

STRANGULATION HAZARD: Child can strangle in loose straps. Never leave child in seat when straps are loose or undone.

The 5-point harness has 3 attachment positions. Select the position that places the shoulder strap level with, or below, the child's shoulder.

To secure the child:

• Place the child in the stroller seat.
• Bring the safety harness around the child's waist and over the shoulders.
• Place the crotch strap between the child's legs.
• Insert the male ends of the shoulder/waist belts into the crotch strap buckle.
• Tighten the harness snugly around the child's waist and over shoulders.

To release the harness: Apply pressure to both sides of each male clip until released. This requires moderate effort to prevent accidental release by the child.

Seat Back Position

WARNING: The upright position should be used only for a child at least 6 months old.

The seat has multiple recline positions controlled by a cord and spring adjuster behind the seat.

• To recline: Pull the adjuster loop backward.
• To move to a more upright position: Grab the adjuster with one hand and pull the cord with the other to the desired position. The cord will lock automatically.

Maintenance

Seat Pad Cleaning

To clean the seat pad, use only mild household soap or detergent and warm water on a sponge or clean cloth.

General Checks

Regularly check your stroller for loose screws, worn parts, torn material, or stitching. Replace or repair parts as needed.