Baby Trend Sit-N-Stand Ultra Stroller

Warranty Information

DO NOT RETURN YOUR PRODUCT TO THE STORE. PLEASE CONTACT BABY TREND® FOR REPLACEMENT PARTS, SERVICE AND REPAIR.

The Baby Trend® warranty covers workmanship defects within 1 year of purchase. Any product subjected to misuse, abuse, abnormal use, excessive wear and tear, improper assembly, negligence, environmental exposure, alteration, or accident, or with an altered/removed serial number, invalidates all claims against the manufacturer. Any damage to property during installation is the sole responsibility of the end user.

Customer Service Department can be contacted at 1 (800) 328-7363 Monday through Friday between 8:00 a.m. and 4:30 p.m. (PST). Return Authorizations are required prior to returning product(s) to Baby Trend®. Please visit http://babytrend.com/pages/limited-warranty for complete warranty details.

Baby Trend, Inc.
13048 Valley Blvd.
Fontana CA 92335

Customer Service: 1-800-328-7363 (8:00am ~ 4:30pm PST)

Website: www.babytrend.com

Safety Warnings

WARNING: Please follow all of these instructions to ensure the safety of your child. Keep these instructions for future reference.

WARNING: Failure to follow these instructions could result in serious injury or death. Avoid serious injury from falling or sliding out, always use the safety harness and ensure that the children are properly positioned according to these instructions.

WARNING: Never leave children unattended.

• Purses, shopping bags, parcels, diaper bags or accessory items may change the balance of the stroller and cause a hazardous, unstable condition.
• Maximum weight capacity: Storage basket: 5 lb (2.26 kg). Parent tray and child tray: 3 lb (1.36 kg). Seat Belt storage pocket (for seat belt only): 1 lb (0.45 kg). Excessive weight may cause a hazardous unstable condition.
• Ensure the stroller is completely opened and locked in place before allowing a child near it.
• Maximum weight: Front seat: 50 lb (22.68 kg). Platform and jump/rear seat: 60 lb (27.21 kg).
• The rear stand on platform and jump/rear seat are designed for a child at least 2 1/2 years old and not over 40 inches (101.6 cm) tall. Total child weight over 110 pounds (49.89 kg) may cause excessive wear, stress, and a hazardous unstable condition.
• NEVER use the stroller on stairways or escalators.
• NEVER allow your stroller to be used as a toy.
• To clean, use only mild household soap or detergent and warm water on a sponge or clean cloth.
• Regularly check your stroller for loose screws, worn parts, torn material, or stitching. Replace or repair parts as needed.
• Discontinue use of stroller if it malfunctions or becomes damaged. Contact customer service for repair or replacement parts.

Parts Identification

Check that you have all the parts for this model before assembling the stroller.

• Stroller (Carrito)
• Front Canopy (Cubierta Delantera)
• Cup Holders (x2) (Portavasos)
• Child Tray (Bandeja para Niños)
• Parent Tray (Bandeja para Padres)
• Front Wheel* (Rueda Delantera*)
• Rear Axle* (Eje Trasero*)

* Wheel styles may vary.

Assembly Instructions

IMPORTANT! To ensure safe operation of your stroller, please follow these instructions carefully. Please keep these instructions for future reference.

IMPORTANT! Before assembly and each use, inspect this product for damaged hardware, loose joints, missing parts, or sharp edges. NEVER use if any parts are missing or broken.

IMPORTANT! Adult assembly is required.

Front Wheels (RUEDAS DELANTERAS)

To attach the front wheels, unfold stroller as described below:

1. Unlock the fold latch (refer to Figure 1a).
2. Unfold stroller frame by sliding the thumb trigger to the left and squeezing the pull trigger (Figure 1b) while pulling backward on the stroller handle (Figure 1a).
3. To attach the front wheels, lean the stroller back so it rests on the handle with front and rear legs pointing upward. Position the front wheels over the front leg tubes, aligning the hole in the housing with the tube, and slide onto the legs (Figure 1c). Push down firmly until the wheels lock securely. Tug each wheel to ensure it is securely attached.

Rear Wheels (RUEDAS TRASERAS)

1. Position the rear axle over the rear leg tubes, with brake pedals facing the back. Push down applying equal pressure to both sides until they lock into place (Figure 2).

NOTE: NEVER use the stroller if the wheels do not lock into place. For assistance, contact customer service at 1-800-328-7363, M-F, between 8am and 4:30pm, PST.

Foot Rest (APOYAPIÉS)

1. Push downward on the foot rest until it snaps onto the U-shaped frame cross member (Figure 3).

Child Tray (BANDEJA PARA NIÑOS)

WARNING: The child's tray is not a restraint device: always secure your child with the seat belt. DO NOT lift the stroller by the child's tray. Use care when attaching the child's tray on the stroller with a child in the stroller.

1. To attach the child tray: Push the tray downward and onto each side of the front armrests until both sides snap into place (Figure 4). NOTE: Check that the tray is securely latched.
2. To access the child seat: Pull one side of the release lever (Figure 5a) located on the underside of the child tray and lift upward. Either side of the child tray will lift and rotate out of the way to allow access to the seat (Figure 5b).
3. To rotate the child tray: To attach an infant car seat, the child tray must be rotated to the vertical position. Press buttons on both sides of the child tray to rotate down 90 degrees (Figure 6).
4. To remove the child tray: Pull both release levers located on the underside of each side of the tray and lift upward (Figure 7).

Parent Tray (BANDEJA PARA PADRES)

1. To attach the parent tray, position the tray so that the hinges for the storage compartment are facing forward. Snap the parent tray to the stand at the top of the frame (Figure 10). NOTE: Check that the tray is securely latched.

Cup Holders (PORTAVASOS)

1. To attach the cup holder: Push the cup holders downward and onto each side of the armrests until it snaps into place (Figure 8). To remove, pull the release lever located on the underside of the cup holder.

Canopy (CUBIERTA)

1. To attach the canopy: Line up the male fittings on the canopy with the slots on the armrest and push both fittings downward until snapped into place (Figure 9).

To open the canopy, push forward on the front edge while holding the rear of the canopy. To close, pull backward on the front edge.

To remove the canopy: Press the snap button under the armrest and pull to release the fitting from the slot. Repeat for the other side (Figure 9b).

NOTE: The canopy is only needed when using the seated position for your child. It is not needed when using with the infant car seat.

Safety Procedures

Brakes (FRENOS)

WARNING: Always set brakes when the stroller is not being pushed so that the stroller will not roll away. NEVER leave stroller unattended on a hill or incline as the stroller may slide down the hill.

1. To engage brakes, apply light downward pressure to the brake lever on each rear wheel. The stroller may require slight forward or rearward movement to align the brake teeth with the wheel brake cluster (Figure 11a). NOTE: Check that the stroller will not move and that both brakes are properly applied.
2. To release, gently lift up on the brake lever (Figure 11b).

Securing the Child (PARA SUJETAR AL NIÑO)

WARNING: Avoid serious injury from falling or sliding out. Always use the safety harness.

STRANGULATION HAZARD: Child can strangle in loose straps. Never leave child in seat when straps are loose or undone.

TANDEM STROLLER - 5-POINT HARNESS (CARRITO EN TÁNDEM - ARNÉS DE 5 PUNTAS):

1. The 5-point harness has 2 attachment positions. Select the loop position that places the shoulder strap level with, or below, the child's shoulder. Feed the shoulder harness under the correct loop. To adjust harness slot, unhook the shoulder strap from the crotch buckle (Figure 12a). Feed the shoulder strap through the harness spread slots (accessible from the rear of the seat). Feed shoulder strap through the appropriate slot and reattach to the crotch buckle.
2. Carefully place the child in the stroller seat. Bring the safety harness around the child's waist and over the shoulders. Place the crotch strap between the child's legs. Insert the male end of each shoulder/waist belt into the buckle on the crotch strap. Tighten the harness to be snug around the child's waist and over the child's shoulders (Figure 12b).
3. To release harness: Push the button on the center clasp; the two harness buckles will pop free (Figure 13). NOTE: Buckles may be hard to release when first used.

Car Seat Safety Belt (CINTURÓN DE SEGURIDAD LA SILLITA PARA EL AUTOMÓVIL)

1. Strap the safety belt over the infant car seat through the seat belt slots on the infant car seat, and connect the buckles (Figure 14a). The safety belts are located in small pockets on the outer sides of seat pads (Figure 14b). Tighten the strap so the infant car seat fits snug and cannot move. IT IS VERY IMPORTANT THAT THE INFANT CAR SEAT STRAP IS ALWAYS TIGHTLY FASTENED AROUND THE INFANT CAR SEAT. NOTE: When the stand feature safety belt is not used, store it back in its storage.

Platform - Safety Belt (PLATAFORMA - Cinturón de Seguridad Trasero)

1. The stroller rear is equipped with a safety belt for the platform. Always secure the stand feature safety belt behind the child and engage the buckle when using the platform (Figure 15a).
2. To release, apply pressure to both sides of each male clip until released. This requires moderate effort to prevent accidental release by your child (Figure 15b).

Operation

To Recline Seats (PARA RECLINAR LOS ASIENTOS)

WARNING: The upright position should be used only for a child that is at least 6 months old.

1. The front seat has two recline positions. To recline the seat, rotate the recline bar and press backward on the seat back (Figure 16). To place the seat in the upright position, press upward on the seat back while rotating the recline bar.

To Attach Infant Car Seat (ADJUNTO DE LA SILLITA PARA EL AUTOMÓVIL)

WARNING: This stroller is NOT compatible with any ALLY Car Seats.

WARNING: To avoid serious injury from falling, ALWAYS use the safety belt to secure the FRONT car seats.

Infant car seat sold separately (visit babytrend.com for compatibility chart).

ATTENTION: The infant car seat may only be attached on the front seat of the stroller.

1. To attach the infant car seat in the front seating position: Attach the child tray in the front seating position and rotate to the vertical position. Place the seat in the reclined position (refer to Figure 16). Set the infant car seat facing toward the rear of the stroller so the seat shell goes into the child tray and latches into place (Figure 17).
2. To remove the Infant Car Seat: Squeeze the release handle located at the foot-end of the seat and carefully lift upward on the seat (Figure 18).

Jump Seat (ASIENTO ADICIONAL)

WARNING: The rear platform and jump seat are designed to accommodate a child who is at least 2 1/2 years old, has good balance and coordination, and is not over 40 inches tall.

Jump Seat: To use jump seat, please remove the child tray (if attached). To remove the rear child tray: See page 9 for details.

Sit on Jump Seat (SIENTE AL NIÑO EN EL ASIENTO ADICIONAL)

1. Have the child sit on the jump seat facing backwards. Secure the child with the jump seat 3-point harness. Part of the 3-point harness is stored in the pocket on the back of the front seat. Put the seat belt around the child's waist, and buckle to the crotch strap. Adjust the seat belt to be snug around the child's waist (Figure 19a).
2. RELEASE! Push the button on the center clasp and all the harness straps will release (Figure 19b).

Stand on the Platform (PARE AL NIÑO EN LA PLATAFORMA)

1. Position the child on the platform on the back of the stroller. Be sure the child is standing facing forward and hands are holding the frame. Secure the stand feature safety belt behind the child and engage the buckle (Figure 20). To release, see step 15. NOTE: Be sure that the child's feet are fully on the platform at all times.

Folding the Stroller (FOLD PLEGAR)

WARNING: Care must be taken when folding and unfolding the stroller to prevent finger entrapment.

CAUTION: Do not allow children near stroller while folding.

1. Close the canopy as described in the canopy section.
2. Pull stroller backward several inches to rotate the front wheels to the front (Figure 21a).
3. To fold the stroller, slide the fold lock with your thumb while squeezing the large fold button in the center of the handle and push forward on the handle (Figure 21b).
4. Once the stroller begins to fold, release the handle and push forward on the handle until the stroller is folded. Lock the fold latch (Figure 21c).

Maintenance

Care and Maintenance (CUIDADO Y MANTENIMIENTO)

Seat Pad (Almohadilla Del Asiento)

• To clean the seat pad, use only mild household soap or detergent and warm water on a sponge or clean cloth.

Other (OTROS)

• Regularly check your stroller for loose screws, worn parts, torn material, or stitching. Replace or repair parts as needed.

Customer Service

The Customer Service Department can be contacted at 1 (800) 328-7363 Monday through Friday between 8:00 a.m. and 4:30 p.m. (PST). Return Authorizations are required prior to returning product(s) to Baby Trend®.