Razor Dirt Quad Battery Replacement Instructions

Step 1

Using a 5 mm Allen wrench, remove the four (4) bolts located on the footrests.

Step 2

Using a Phillips screwdriver, remove the two (2) screws on both the left and right sides of the front of the unit.

Step 3

Using a 13 mm open wrench, loosen and remove the bolt from the steering arm that connects it to the steering tube.

Step 4

Using a 10 mm open wrench, remove the two (2) lock nuts under the seat.

Step 5

Lift and remove the steering tube from the frame. The brake cable may need to be disconnected from the caliper.

Step 6

Lift and remove the body fairing from the unit. Unplug the connectors between the battery and the controller.

Step 7

Using a Phillips screwdriver, remove four (4) screws from the right side of the battery cover.

Step 8

Using a 5 mm Allen wrench, loosen and remove the four (4) hex bolts located on the bottom of the battery cover.

Step 9

Remove the battery covers.

Step 10

Using a 4 mm Allen wrench, loosen and remove the two (2) hex bolts that hold the battery bracket in place. Use both hands to lift and remove the batteries.

Step 11

To install a new battery, reverse steps 1-10.

ATTENTION: Charge battery 12 hours before using.