Razor DIRT QUAD INNER TUBE REPLACEMENT INSTRUCTIONS

Required Tools: (Not included)

• 6 mm Allen wrench
• 13 mm wrench
• Phillips screwdriver

⚠️ WARNING

CAUTION:

To avoid potential shock or other injury, turn power switch OFF and disconnect charger before conducting any assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage.

Instructions

Step 1

Using a 6 mm Allen wrench, loosen and remove the four (4) bolts that hold the wheel in place and pull the wheel out.

[Image description: A Razor Dirt Quad wheel with four bolts circled in white, indicating the bolts to be removed.]

Step 2

Remove the valve stem cover. Using a Phillips screwdriver, remove any air left in the inner tube.

[Image description: A hand using a Phillips screwdriver to deflate a tire by pressing on the valve stem.]

Step 3

Using a 13 mm wrench and a 6 mm Allen wrench, remove the nuts and bolts that keep the rim together.

[Image description: A Razor Dirt Quad wheel with a 13mm wrench and a 6mm Allen wrench being used to remove bolts holding the rim halves together.]

Step 4

Once you remove the bolts and nuts from the rim, you will be able to split the rim in half.

[Image description: A Razor Dirt Quad wheel rim split into two halves, with bolts and nuts visible.]

Step 5

Remove the inner tube from inside the tire.

[Image description: A deflated inner tube being removed from a tire, with the two rim halves lying nearby.]

Step 6

To install a new inner tube, reverse steps 1-5.

• Re-install your inner tube and rim and secure with bolts.
• Re-install your wheel and secure it with the bolts.

ATTENTION: Charge battery 12 hours before using.

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.