ETA Storio 9186 Stainless Steel Water Kettle

Introduction

Thank you for purchasing the ETA Storio 9186 stainless steel water kettle. Please keep this manual, along with the warranty card and proof of purchase, for future reference. This manual contains important information regarding the safe operation, maintenance, and technical specifications of your appliance.

Safety Warnings

⚠️ Before first use, read instructions carefully, examine diagrams, and keep for future reference. Consider instructions as part of the appliance.

• Check if the voltage on the type label matches your socket. Connect only to a properly connected and grounded socket.
• This appliance can be used by children aged 8 years and older, and by persons with reduced physical, sensory, or mental capabilities, or lack of experience, if they are supervised or instructed on safe use and understand the risks.
• Children under 8 years must be kept out of reach of the appliance and its power cord.
• Children must not play with the appliance.
• The kettle is intended for heating a maximum of 1.7 liters of water. Exceeding this may cause hot water to splash out.
• WARNING: Do not open the lid when the water is boiling or very hot.
• WARNING: Position the lid so steam escapes away from the handle.
• CAUTION: Do not use with timers or automatic switches, as this poses a fire risk if the appliance is covered or misplaced.
• Prevent pets, plants, or insects from contacting the appliance during operation.
• Do not plug in or unplug the power cord with wet hands or by pulling the cord.
• Use the kettle only with its designed stand.
• Prevent injuries from hot water or steam.
• The appliance has a heat safety lock that disconnects power if the steam sensor fails, water boils away, or an empty kettle is turned on. If this occurs, unplug and let it cool. Do not cool rapidly with cold water, as it may reduce the heating element's lifespan.
• Use the appliance only for its intended purpose as described in this manual.
• The producer is not responsible for damage caused by improper use or failure to comply with safety warnings.
• Never immerse the kettle or stand in water or other liquids.
• The kettle must not be used without the filter sieve.
• Never leave the appliance unsupervised during heating.
• Not intended for outdoor use.
• Intended for domestic and similar use (shops, offices, hotels, etc.), not commercial use.
• Only heat water; do not use for other liquids. Do not add tea bags, loose tea, or other beverage additives directly into the kettle.
• Use on a stable, level surface away from heat sources, flammable objects, and wet surfaces.
• Do not place near objects that could be damaged by steam (e.g., walls, cupboards, curtains).
• Do not use in environments with explosive or flammable vapors.
• Ensure water is in the kettle before operation. Do not fill while on the stand.
• Do not touch outer surfaces during operation; they are hot. Do not touch the lid during or after boiling.
• Ensure water level is between MIN and MAX marks before switching on.
• If not using for an extended period, unplug the stand from the power outlet.
• If the power cord is damaged, it must be replaced by the manufacturer, service technician, or similarly qualified person.
• Never use if the cord or plug is damaged, if it malfunctions, if dropped, or if it fell into water. Take it to a service center.
• Do not place the power cord on hot surfaces or let it hang over edges.
• Ensure the power cord is not damaged by sharp or hot objects, or open fire. Do not immerse in water or bend over sharp edges.
• Use extension cords only if they are undamaged and meet standards.

Description of the Appliance

The appliance consists of a kettle (A) and a removable stand (B).

Kettle (A) Components:

• A1: Off/on button (0/1, steam sensor switch)
• A2: Control light
• A3: Water gauge
• A4: Handle
• A5: Lid
• A6: Filtration sieve

Removable Stand (B) Components:

• B1: Central connector
• B2: Power cord

The steam sensor switch ensures automatic shut-off after boiling.

Instructions for Use

Initial Use:

Before the first use, fill the kettle with clean water to the maximum level, turn it on, and let it boil. Pour out the water and repeat this process at least five times to clean the appliance and remove any potential plastic taste.

Operation:

1. Unwind the power cord (B2) from the stand (B) to the required length.
2. Plug the power cord into an electrical socket.
3. Hold the kettle (A) by the handle (A4).
4. Open the lid (A5) and fill the kettle with drinking water. The minimum and maximum water levels are marked on the water gauge (A3).
5. Close the lid securely.
6. Place the filled kettle on the stand (B).
7. Turn the switch (A1) to position 'I' to start heating. The control light (A2) will illuminate.
8. The appliance will automatically switch off when the water boils.
9. You can switch off the kettle manually by turning the switch (A1) to position '0' before it reaches boiling point.

Attention Points:

• The lid must be closed for the automatic shut-off function to work.
• Tilting the kettle backwards, especially when full, may cause water to leak from the bottom. This is not a safety issue or malfunction. However, tilting with hot water poses a scalding risk, so avoid tilting.
• When the kettle is not in use, do not leave it on the connected stand.
• If the kettle is removed from the stand during boiling, it remains in the ON state and will resume heating immediately upon being placed back on the stand.

Maintenance

⚠️ Before any maintenance, unplug the appliance from the power supply and allow it to cool down completely.

Do not use abrasive or aggressive cleaning agents (e.g., sharp objects, scrapers, solvents). The stainless steel casing and heating base may accumulate water impurities (limescale), especially above the heating element. This is normal and not a defect.

Cleaning the Kettle:

To remove limescale, use an ETA-AKTIV descaler or the following method:

1. Add approximately 50g of citric acid to the kettle.
2. Fill the kettle halfway with water and mix.
3. After dissolving, fill to 3/4 of the maximum water level.
4. Place the kettle on the stand and switch it on.
5. Before boiling, turn off the kettle, let the solution work for about 10 minutes, then pour it out.
6. Rinse thoroughly with clean water. Repeat if heavily soiled.
7. Clean the kettle regularly.

Cleaning the Sieve (A6):

Remove the sieve from the kettle. Clean it under running water with a soft brush to remove any deposits. Reinsert the sieve in the reverse order.

Extensive maintenance or repairs requiring access to internal parts must be performed by authorized service personnel. Failure to follow manufacturer's instructions voids the warranty.

Environment

♻️ Symbols on the product or documentation indicate that used electrical and electronic products should not be disposed of with household waste. Please return them to designated collection points for free recycling. Proper disposal helps conserve natural resources and prevent negative environmental and health impacts. Contact local authorities or collection points for details. Incorrect disposal may result in penalties.

If the appliance is to be permanently decommissioned, cut the power cord to render it unusable.

Technical Data

The manufacturer reserves the right to change technical specifications and accessories without notice.

Warnings and Symbols Used

• HOUSEHOLD USE ONLY – For domestic use only.
• DO NOT IMMERSE IN WATER OR OTHER LIQUIDS – Do not submerge the appliance in water or other liquids.
• ⚠️ TO AVOID DANGER OF SUFFOCATION, KEEP THIS PLASTIC BAG AWAY FROM BABIES AND CHILDREN. DO NOT USE THIS BAG IN CRIBS, BEDS, CARRIAGES OR PLAYPENS. THIS BAG IS NOT A TOY. – Keep plastic bags away from children to prevent suffocation risk.
• The ⚠️ symbol indicates a WARNING.