DOD Carcosa Fuzz [PRT]

Controls

The DOD Carcosa Fuzz pedal features the following controls and connections:

• 1. BEFORE: Adjusts the amount of fuzz.
• 2. OUTPUT: Adjusts the overall output level. Provides ample volume, usable as a boost.
• 3. AFTER (Bias Control): Alters the fuzz texture. Counter-clockwise yields "woody" high-fuzz tones, clean with guitar volume knob. Clockwise yields "broken" fuzz tones, vowel-like "horn" sounds, and sustain. Mid-range covers classic familiar to modern "wall of sound" fuzz.
• 4. HI-CUT: Reduces high-frequency detail. Start at 9:00 and adjust counter-clockwise for brighter pickups, clockwise for darker pickups. Experiment with extreme settings, as AFTER control changes also affect fuzz tone. High volume or stage settings may require high-frequency adjustment.
• 5. IN: Connect your instrument here.
• 6. DEMHE/HALI (Toggle Switch):
  
  • DEMHE (Up): Provides a bass and low-mid boost, excellent for clean channels.
  • HALI (Down): Provides a bass cut, excellent for dirty channels.
• 7. FOOTSWITCH: Engages/disengages the effect.
• 8. LED: Illuminates when the effect is active.
• 9. OUT: Connect to the next pedal or your amplifier input.

Diagram Descriptions

The pedal features artwork with a skull and yellow/black patterns, with the "CARCOSA FUZZ" logo. The control layout is as follows:

• Control Knobs: Located on the top panel are BEFORE, OUTPUT, AFTER, and HI-CUT.
• Toggle Switch: Positioned between the controls, labeled DEMHE/HALI.
• Footswitch: Centered at the bottom, with an LED indicator above it.
• Input Jack: Labeled "IN" on the right side of the pedal.
• Output Jack: Labeled "OUT" on the left side of the pedal.

Control Range Graphics:

• AFTER (Bias) Control Ranges: A graphic shows the spectrum from "Low Gain Range Reduced Treble Content" (counter-clockwise) to "High Gain Range Increased Treble Content" (clockwise).
• HIGH-CUT Control Ranges: A graphic illustrates "Extreme Range Gated/Sputter 'Horn-Like' Sounds" (counter-clockwise), a "Normal Operating Range" in the center, and "Treble Make-Up Range For Low AFTER (Bias) Settings" and "Extreme Range To Compensate For Extreme Sag/Gate AFTER Settings" (clockwise).

Usage and Tone

The DOD Carcosa Fuzz offers an alternative fuzz universe, blending classic legendary tones with abstract sounds. The combination of its extensive AFTER bias control and two toggle positions creates tones from "pork rind fatness" to "desiccated fragments." This versatility makes the Carcosa Fuzz a good companion for both dirty and clean amplifiers. It features true bypass, ample output, and the "King of Yellow" motif.

The DOD Carcosa Fuzz has an exaggerated mid and treble character, helping it cut through a mix. It is designed to cut through dense, heavy bands while maintaining note articulation with chords. Extreme AFTER bias settings allow for wild, exaggerated sounds.

Amplifier Interaction:

• Clean Amps: DEMHE mode boosts low-mids, pairing well with American combo amps (with bright switch off). It also sounds great with British amps on the edge of breakup, thickening the tone and pushing the amp into saturation.
• Dirty Amps: HALI mode keeps bass tight, and HI-CUT provides high-frequency detail for a lead amp. This makes the Carcosa excellent for a fuzzy lead boost.

Fuzz Voicings: Wide fuzz voicings are possible. Lower AFTER (counter-clockwise) settings respond well to guitar volume and attack dynamics, cleaning up controllably like classic overdrives. Higher AFTER (clockwise) settings make gain and attack less responsive to volume changes, yielding more aggressive fuzz, even synthesized horn-like tones.

HI-CUT Usage: The HI-CUT control rarely needs to go past noon. The rest of the range compensates for attack loss and extreme sag caused by higher AFTER settings.

General Tip: Setting BEFORE and AFTER controls in opposite positions (e.g., BEFORE at 3:00, AFTER at 9:00, or vice-versa) can produce a wide range of controllable tones. Experimentation is encouraged for finding unique sounds.

Placement: Most guitarists/bassists prefer placing the Carcosa at the beginning of their effects chain. A typical chain is: Distortion/Fuzz -> Modulation (Chorus, Flanger, Phaser, Tremolo) -> Time-based (Delay, Reverb). Placing the Carcosa first preserves its character regardless of subsequent pedals.

Specifications

• Input: 1/4" TS Unbalanced - 500 kΩ
• Output: 1/4" TS Unbalanced - 1 kΩ
• Current Draw: 4 mA
• Bypass: True Bypass
• Power: 9VDC alkaline battery (not included) or PS0913DC power adapter (optional).
• Warranty: 1 Year

Manufacturer Information

DOD
59 Hwagok-ro 61gil Ganseo-gu, Seoul 07590 Republic of Korea
support@digitech.com

Compliance and Safety Instructions

Altitude Warning: Indicative of low altitude use; do not use above 2,000 m. [Altitude Symbol: 2000m]

Electrical Safety Symbols: The following symbols indicate potential hazards with electrical products:

• Lightning bolt in triangle: Indicates dangerous voltages are present.
• Exclamation mark in triangle: User must consult the owner's manual.

These symbols also indicate there are no user-serviceable parts inside. Do not open the unit. Do not attempt to repair it yourself; refer all servicing to qualified personnel. Opening the chassis for any reason will void the manufacturer's warranty. Do not expose the unit to rain or moisture. If liquid spills, unplug immediately and seek service. Unplug during thunderstorms to prevent damage.

UK Mains Plug Warning: A molded plug cut from the cord is unsafe. Dispose of the plug in an appropriate disposal location. NEVER insert a damaged or cut power plug into a 13 AMP power socket. Do not use the plug without the fuse cover in place. Replacement fuse covers can be obtained from your local dealer. Replacement fuses are 13 amps and MUST be ASTA approved according to BS1362.

Product Disposal: Do not mix this product with general household waste. There is a separate collection system for used electronic products, requiring proper treatment, recovery, and recycling. Households in EU member states, Switzerland, and Norway can return used electronics free of charge to designated collection centers or a retailer. For other countries, contact local authorities for correct disposal methods to prevent negative environmental and health effects.

General Safety Warnings:

• Read and save these instructions.
• Heed all warnings.
• Follow all instructions.
• Do not use this apparatus near water.
• Clean only with a dry cloth.
• For indoor use only.
• Do not block any ventilation openings. Install according to the manufacturer's instructions.
• Do not install near heat sources like radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
• Use only manufacturer-specified attachments/accessories.
• Unplug this apparatus during lightning storms or when unused for long periods.
• Do not defeat the safety purpose of polarized or grounded plugs. If the provided plug does not fit your outlet, consult an electrician to replace the obsolete outlet.
• Protect the power cord from being walked on or pinched, especially at plugs, convenience receptacles, and the point where it exits the apparatus.
• Use only with the cart, tripod, or table specified by the manufacturer or sold with the apparatus. When using a cart, use caution when moving the cart/apparatus combination to avoid injury from tipping.
• Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as a damaged power-supply cord or plug, liquid has been spilled, or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
• Power Switch: The switch used in this equipment does NOT disconnect the unit from the mains.
• Mains Disconnection: The plug must remain readily operable. For rack mounting or installation where the plug is not accessible, a multi-pole mains switch with a contact separation of at least 3 mm in each pole must be incorporated into the rack or building's electrical installation.
• If connected to a 240 V source, an appropriate CSA/UL certified power cord must be used.

Power Cable Wiring Instructions:

WARNING: THIS APPARATUS MUST BE CONNECTED TO A PROTECTED EARTH MAINS SOCKET.

The power cord conductors are colored according to the following code:

• GREEN AND YELLOW – EARTH / BLUE – NEUTRAL / BROWN - LIVE

Since the colors of the conductors of the power cord of this apparatus may not correspond with the color markings identifying the terminals of your plug, proceed as follows:

• The GREEN AND YELLOW colored conductor MUST be connected to the plug terminal marked with the letter E, or with the Earth symbol, or colored GREEN, or GREEN AND YELLOW.
• The BLUE colored conductor MUST be connected to the terminal marked N or colored BLACK.
• The BROWN colored conductor MUST be connected to the terminal marked L or colored RED.

This equipment may require the use of a different line cord, fitting, or both, depending on the power supply available in the installation. If the attachment plug needs to be altered, consult service to qualified service personnel who should consult the table below. The GREEN/YELLOW wire must be connected directly to the chassis of the unit.

Wire Color Table:

WARNING: IF THE GROUND IS DEFEATED, CERTAIN FAILURE CONDITIONS IN THE UNIT OR SYSTEM TO WHICH IT IS CONNECTED MAY RESULT IN FULL LINE VOLTAGE BETWEEN THE CHASSIS AND GROUND. SERIOUS INJURY OR DEATH MAY OCCUR IF THE CHASSIS AND GROUND ARE TOUCHED SIMULTANEOUSLY.

• Google Docs
• Google Drive
• Download [pdf]



File Info : application/pdf, 6 Pages, 737.62KB

Document Document

Related Documents

	DOD Carcosa Fuzz [DNK] - Guitar Effects Pedal User Manual and Specifications Comprehensive guide to the DOD Carcosa Fuzz guitar effects pedal, covering its controls, usage, sound characteristics, technical specifications, and essential safety information. Discover versatile fuzz tones for guitarists.
	DOD Carcosa Fuzz [HRV] Guitar Pedal User Manual and Guide Comprehensive guide to the DOD Carcosa Fuzz guitar pedal, detailing its unique controls, versatile sound shaping, technical specifications, and essential safety information for musicians.
	DOD Carcosa Fuzz Guitar Pedal: Features, Specifications, and Safety Guide Explore the DOD Carcosa Fuzz, a versatile guitar effects pedal known for its wide range of fuzz tones. This guide covers its controls, usage, specifications, and important safety instructions.
	DOD Carcosa Fuzz Guitar Pedal: Features, Controls, and Usage Guide Detailed information on the DOD Carcosa Fuzz guitar pedal, covering its controls, sound shaping capabilities, technical specifications, and important safety guidelines. Perfect for guitarists seeking versatile fuzz tones.
	DOD Chthonic Fuzz Guitar Pedal: Controls, Specifications, and Safety Comprehensive guide to the DOD Chthonic Fuzz guitar pedal, detailing its controls, recommended placement, technical specifications, and essential safety instructions for musicians.
	DOD Carcosa Fuzz Guitar Pedal User Guide Comprehensive guide to the DOD Carcosa Fuzz guitar pedal, detailing controls, usage, specifications, and safety information for musicians.
	DOD Chthonic Fuzz Guitar Pedal - Features, Specifications, and Manual Detailed information on the DOD Chthonic Fuzz guitar pedal, including controls, placement, setup, specifications, and safety guidelines. Learn how to get the most out of this fuzz effect.
	DOD Chthonic Fuzz Guitar Effects Pedal - User Manual and Specifications Comprehensive user manual and specifications for the DOD Chthonic Fuzz guitar effects pedal. Learn about its controls, positioning, settings, and important safety information.