Juno Trac-Master®

DIMMING COMPATIBILITY

Approved Acuity Dimming Systems:

Electronic Low Voltage - Reverse Phase Dimming

• Dimmable using Acuity nLight wired dimming controls, including Fresco controllers, when combined with an nLight nSP5 PCD ELV 120 Secondary Relay and Dimming Pack (required) at the trac input. Dimming range of 100% down to 2% typical with a minimum load of one fixture and maximum load of 475W @ 120VAC.

*Typical dimming range based on laboratory evaluation - actual installation conditions and results may vary.

Approved Non-Acuity Dimming Methods:

Electronic Low Voltage - Reverse Phase Dimming

• Dimmable with the use of most electronic low voltage dimmers. Electronic low voltage dimmers require a neutral wire in the wall box.
• Dimming range of 100% down to 20% or lower with a minimum load of one fixture and a maximum load of 75% of the dimmer rated load (see example); both dimming range and maximum rated load may vary depending on dimmer model.

Example: Typical Fixture Power Consumption = 10W
Dimmer Rating = 600W
Equivalent Incandescent Load (EIL) Factor = 75% (0.75)
(600/10) X 0.75 = 45 Fixtures per Dimmer

Juno Qualified Dimmers include:

Lutron® Model Numbers:

• Nova T NTELV Series
• Diva® DVELV Series
• Skylark® SELV Series

Consult technical services for additional information regarding other dimmer model qualification.