Juno Trac-Master Cylindra LED Dimming Compatibility
Avant Garde Series
Models: CYLINDRA™ 35W LED, T255LG2, TEK255LG2
Dimmer Compatibility
Approved Acuity Dimming Systems
Electronic Low Voltage - Reverse Phase Dimming
- Dimmable using Acuity nLight wired dimming controls, including Fresco controllers, when combined with an nLight nSP5 PCD ELV 120 Secondary Relay and Dimming Pack (required) at the trac input.
- Dimming range: 100% down to 1% typical.
- Minimum load: One fixture.
- Maximum load: 475W @ 120VAC.
*Typical dimming range based on laboratory evaluation - actual installation conditions and results may vary.
Approved Non-Acuity Dimming Methods
Electronic Low Voltage - Reverse Phase Dimming
- Dimmable with the use of most electronic low voltage dimmers.
- Electronic low voltage dimmers require a neutral wire in the wall box.
- Dimming range: 100% down to 20% or lower with a minimum load of one fixture and a maximum load of 75% of the dimmer rated load (see example).
- Both dimming range and maximum rated load may vary depending on dimmer model.
Example Calculation:
Typical Fixture Power Consumption = 10W
Dimmer Rating = 600W
Equivalent Incandescent Load (EIL) Factor = 75% (0.75)
(600/10) X 0.75 = 45 Fixtures per Dimmer
Juno Qualified Dimmers include:
Lutron® Model Numbers:
- Diva® DVELV Series
- Nova T NTELV Series
- Skylark® SELV Series
Consult technical services for additional information regarding other dimmer model qualification.
