KRANBALK Ceiling Lamp Assembly
Brand: IKEA
Safety First
⚠️ For indoor use only.
IMPORTANT: Always disconnect power to the circuit before commencing installation. In certain regions, electrical installations must be performed by a certified electrician. Consult your local electrical authority for guidance.
Included Components
This package typically contains:
- Lamp body with arms
- 3x Lamp holders
- 3x Glass shades
- Mounting hardware and terminal block
Installation Guide
-
Step 1: Orient the lamp body. Ensure arms are correctly positioned. A crossed-out diagram indicates incorrect orientation.
-
Step 2: Secure the lamp arms. Rotate each arm into its final position, as shown by the curved arrow.
-
Step 3: Attach the lamp holders. Screw the three lamp holders (3x) onto the ends of the arms.
-
Step 4: Insert light bulbs. Screw the light bulbs into the attached lamp holders.
-
Step 5: Secure the glass shades. Twist or screw the three glass shades onto the lamp holders.
-
Step 6: Prepare for ceiling attachment. The main lamp body is shown connecting to the ceiling canopy, likely via a central threaded rod.
-
Step 7: Wiring: Open the terminal block. The diagram illustrates opening the cover of an electrical terminal block where the power cable will be connected.
-
Step 8: Wiring: Insert wires. Push the prepared power cable wires into the terminal block connection points.
-
Step 9: Suspend the fixture. Hang the ceiling canopy from a ceiling hook. Ensure the suspension wire length is between 20-35 mm (3/4" - 1 3/8").
-
Step 10: Prepare the power cable. Strip approximately 20 mm (3/4") of insulation from the ends of the power cable wires.
-
Step 11: Connect wires to terminal block. Insert the Line (L) and Neutral (N) wires into their corresponding terminals in the block.
-
Step 12: Secure wiring. Close the terminal block cover until it clicks, ensuring the wires are firmly held.
-
Step 13: Mount the fixture. Attach the main lamp body to the ceiling canopy by screwing it onto the mounting rod.
-
Step 14: Final wiring check. Ensure all wire connections within the terminal block are secure.
-
Step 15: Complete installation. Re-attach the main lamp body to the ceiling canopy, securing it firmly.
