VEVOR Electric Bed Lift

Product Overview

This document provides essential information for the VEVOR Electric Bed Lift, including operating instructions, safety precautions, and installation guidance. It covers various models such as D603-75, D603-75F, D603-75F-01, C603-90F, and C603-90F-01.

Please read all manual instructions carefully before operating the electric bed lift. VEVOR reserves the right to interpret its user manual, and product appearance is subject to the item received.

Key Features and Specifications

• Models: D603-75, D603-75F, D603-75F-01, C603-90F, C603-90F-01
• Power Input: 100-240V, 1.5A
• Output: DC29V, 2A
• Working Power: Approximately 50W
• Frequency: 50/60HZ

Important Safety Information

• Read instructions carefully to reduce the risk of injury.
• Do not allow children to operate or play with the appliance unsupervised.
• Avoid sitting or lying on the backrest during lifting.
• Ensure connecting wires are not squeezed or dragged to prevent damage.
• For adapter safety, use only for indoor purposes and ensure correct polarity.
• Children aged 8 and above, and individuals with reduced capabilities, may use the appliance under supervision.

Correct Disposal

This product complies with European Directive 2012/19/EU. Products marked with the crossed-out wheelie bin symbol require separate collection for recycling electrical and electronic devices. Do not discard with normal domestic waste.

FCC Information

This device complies with Part 15 of the FCC Rules. Operation is subject to conditions that may prevent harmful interference. If interference occurs, measures like reorienting the antenna or increasing distance between the product and receiver may help.

Instructions for Use

1. Place the electric mattress flat on the bed surface.
2. Ensure the remote control cable and power cord are properly threaded through armrest holes.
3. Plug in the power cord and verify the power is on.
4. Use the remote control buttons to ascend, descend, or stop the lift.

Armrest Installation

Align armrest screw holes with the mattress screws and tighten. The installation method is the same for both fixed and folding armrests.

Manufacturer and Support

Manufacturer: Shanghaimuxinmuyeyouxiangongsi

Address: Shuangchenglu 803nong11hao1602A-1609shi, baoshanqu, shanghai 200000 CN.

For technical support and e-warranty information, visit www.vevor.com/support.

Imported to AUS: SIHAO PTY LTD. 1 ROKEVA STREETEASTWOOD NSW 2122 Australia

Imported to USA: Sanven Technology Ltd. Suite 250, 9166 Anaheim Place, Rancho Cucamonga, CA 91730

UK Representative: YH CONSULTING LIMITED. C/O YH Consulting Limited Office 147, Centurion House, London Road, Staines-upon-Thames, Surrey, TW18 4AX

EU Representative: E-CrossStu GmbH Mainzer Landstr.69, 60329 Frankfurt am Main.