VEVOR Electric Bed Lift

Product Models

Models: D603-75 / D603-75F / D603-75F-01 / C603-90F / C603-90F-01

This is the original instruction. Please read all manual instructions carefully before operating. VEVOR reserves the right to interpret its user manual. The appearance of the product is subject to the product received. VEVOR may not provide further notice for technology or software updates.

Product Images

Image 1: A VEVOR Electric Bed Lift, model D603-75, shown in a raised position with a headrest and footrest.

Image 2: A VEVOR Electric Bed Lift, model D603-75F/D603-75F-01, shown in a raised position with a headrest and footrest.

Image 3: A VEVOR Electric Bed Lift, model C603-90F/C603-90F-01, shown in a raised position with a headrest and footrest.

Parameters

Warning: To reduce the risk of injury, user must read instructions manual carefully.

Matters Needing Attention

1. Do not allow children to operate and use it alone.
2. Do not sit/lie on the top of the backrest during lifting.
3. Do not let children play around the back of the product after lifting.
4. Do not squeeze/drag the connecting wires to avoid damage, short circuit, and leakage.

Warning for adapter:

For type Y attachment:

• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons to avoid a hazard.
• For indoor use only.
• Do not use the charger if the output polarity does not match the load polarity.
• Under no circumstances should the cover be opened. If the cover is damaged, the adapter may no longer be used.
• This appliance can be used by children aged 8 years and above, and persons with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not be made by children without supervision.

Correct Disposal

This product is subject to the provision of European Directive 2012/19/EU. The symbol showing a wheelie bin crossed through indicates that the product requires separate refuse collection in the European Union. This applies to the product and all accessories marked with this symbol.

Products marked as such may not be discarded with normal domestic waste but must be taken to a collection point for recycling electrical and electronic devices.

[Recycling Symbol]

FCC Information

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment!

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This product may cause harmful interference.
2. This product must accept any interference received, including interference that may cause undesired operation.

WARNING: Changes or modifications to this product not expressly approved by the party responsible for compliance could void the user's authority to operate the product.

Note: This product has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This product generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this product does cause harmful interference to radio or television reception, which can be determined by turning the product off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the distance between the product and receiver.
• Connect the product to an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for assistance.

Instructions

When using, it is necessary to lay a mattress or quilt on the electric mattress for better comfort. This product is relatively heavy, and users are not recommended to move it frequently.

1. Take out the electric mattress and lay it flat on the bed surface.
2. Check that the remote control cable and power cord are threaded out of the armrest hole. Press under the bed frame, otherwise it may cause pulling and damage the lifting mechanism.
3. Plug in the power and check if the plug is powered on properly.
4. Press the remote control button. The left side is for ascending, and the right side is for descending. Keep pressing the button to adjust the height; release to stop.

Remote Control Functions:

• Up button [▲]
• Lowering button [▼]

Bed Cover Removal: If you need to remove the bed cover, the zipper is on the back of the cushion.

Warning: Ensure wires are threaded through armrest holes and do not damage the circuit.

Armrest Installation

1. Align the screw holes on the armrest with the screws on the electric mattress.
2. Insert the screws into the gasket and tighten them.

Note that the armrest is divided into fixed armrest (D603-75F/D603-75F-01) and folding armrest (C603-90F/C603-90F-01). The installation method is the same.

Required Components:

• M8 screw x4
• 5mm wrench x1
• Shim x4

Visual Aid:

Image: Illustration showing the armrest alignment with screws and gaskets.

Image: Illustration of an M8 screw.

Image: Illustration of a 5mm wrench.

Image: Illustration of a shim.

Manufacturer and Importer Information

Manufacturer: Shanghaimuxinmuyeyouxiangongsi

Address: Shuangchenglu 803nong11hao1602A-1609shi, baoshanqu, shanghai 200000 CN.

Imported to AUS: SIHAO PTY LTD. 1 ROKEVA STREET EASTWOOD NSW 2122 Australia

Imported to USA: Sanven Technology Ltd. Suite 250, 9166 Anaheim Place, Rancho Cucamonga, CA 91730

UK REP: YH CONSULTING LIMITED. C/O YH Consulting Limited Office 147, Centurion House, London Road, Staines-upon-Thames, Surrey, TW18 4AX

EC REP: E-CrossStu GmbH Mainzer Landstr.69, 60329 Frankfurt am Main.