Legrand CWDM-SFP-40-I-XX

Features

• Up to 1.25Gb/s Data Links
• Hot-Pluggable ?
• Duplex LC connector
• Up to 40km on 9/125µm SMF
• 1470nm~1610nm DFB laser transmitter
• PIN Receiver
• Single +3.3V Power Supply
• Monitoring Interface Compliant with SFF-8472
• Low power dissipation <1W typically
• Industrial operating temperature range: -40°C to 85°C
• RoHS compliant and Lead Free ✅

Applications

• Metro/Access Networks
• 1.25 Gb/s 1000Base-EX Ethernet
• 1xFibre Channel
• CWDM Networks

1. Absolute Maximum Ratings

Operation in excess of any absolute maximum ratings might cause permanent damage to this module.

2. Recommended Operating Environment

3. Electrical Characteristics

(TOP = -40 to 85°C, VCC = 3.135 to 3.465 Volts)

Notes:

1. AC coupled.
2. Or open circuit.
3. Into 100 ohm differential termination.
4. 20-80%
5. LOS is LVTTL. Logic 0 indicates normal operation; logic 1 indicates no signal detected.
6. All transceiver specifications are compliant with a power supply sinusoidal modulation of 20 Hz to 1.5MHz up to specified value applied through the power supply filtering network shown on page 23 of the Small Form-factor Pluggable (SFP) Transceiver Multi-Source Agreement (MSA), September 14, 2000.

4. Optical Parameters

(TOP = -40 to 85°C, VCC = 3.135 to 3.465 Volts)

Notes:

1. The optical power is launched into SMF.
2. 20-80%.
3. Jitter measurements taken using Agilent OMNIBERT 718 in accordance with GR-253.
4. Measured with PRBS 27-1 at 10^-12 BER

5. Mechanical Diagram

A diagram illustrating the physical dimensions of the transceiver module. The diagram shows three views: front, side, and top. Key dimensions are labeled: 13.9mm, 58.4mm, 57.5mm, 45±0.2mm, 13.9mm, 8.5±0.1mm, 13.7+0/-0.2mm, and 6.25mm.

Note: External physical characteristics are subject to variation. This may include, but is not limited to, external case designs, pull tab colors and/or shapes, removal latch styles or colors, and label sizes and placement. These variations do not affect the function or characteristics of the transceivers.

6. Ordering Information

This section provides a table listing various Original Equipment Manufacturer (OEM) part numbers and their corresponding part numbers for different vendors including Ciena, Extreme, Juniper, Cisco, and MSA. The table includes part numbers such as NTK59127-L, 1G-SFP-CWDM40-1450-L, SFP-GE40KCW1270-L, CWDM-SFP-1270-40-L, and CWDM-SFP-40-27-L, covering a range of CWDM wavelengths and specifications.