CHIPHY Athena LED Desk Lamp
Model: RD1001
Specifications
| Model | RD1001 |
| Dimensions | D7.3*H16.2inch |
| Material | Aluminum alloy/Steel |
| Power | 20W |
| Volt | 100-240V |
| Frequency | 50/60Hz |
| Luminous flux | 1500lm |
| CCT | 4000K |
| CRI | Ra≥95 |
| Lifespan | 50000h |
How to Operate
Short-press [Mode/Power Button] one time. Turn on/off.
When the light is off, long-press [Mode/Power Button] for 1s for "Night light" Mode.
7 brightness levels;
Short-press [Brightness Up] or [Brightness Down] to adjust brightness;
Long-press [Brightness Up] for 1s for maximum brightness;
Long-press [Brightness Down] for 1s for minimum brightness;
45mins Timing: When the light is on, long-press [Mode/Power Button] for 1s, the light flashes two times, setup is done.
60s Timing: When the light is on, double-press [Mode/Power Button], the light flashes two times, setup is done.
The most recently selected brightness is also remembered by Athena after switching back on.
Installation Guide
Parts Identification Guide
- A*1: Lamp head assembly
- B*1: Power adapter
- C*1: Lamp pole
- D*1: Lamp base
Assembly Steps
Follow these steps to assemble your CHIPHY Athena LED Desk Lamp:
- Step 1: Attach the lamp pole (C) to the lamp base (D). Refer to "Matters Needing Attention - Note 1" for connection details.
- Step 2: Attach the lamp head assembly (A) to the top of the lamp pole (C).
- Step 3: Connect the power adapter (B) to the lamp.
Matters Needing Attention
Note 1: When connecting the lamp pole to the base, ensure the parts are properly aligned and secured. The power cable should be routed correctly through the designated connectors.
Note 2: Warning: ? [Do Not Rotate]. Do not twist or rotate the lamp head assembly after it is attached to the pole. This could damage the internal components.
