Yaheetech 591862 Hall Table Assembly Instructions
Introduction
Welcome to your new Yaheetech Hall Table. Please read these instructions carefully before beginning assembly to ensure a smooth and correct setup.
Important: Keep all hardware and small parts away from children during assembly.
Parts List
Before you begin, please verify that you have all the parts listed below. If any parts are missing or damaged, please contact customer support.
- 1 x Tabletop
- 4 x Table Legs
- 1 x Lower Shelf (if applicable)
- Hardware Pack (screws, bolts, Allen wrench, etc.)
[Diagram of parts would typically be here, showing each component labeled.]
Assembly Steps
Step 1: Attach Legs to Tabletop
Place the tabletop upside down on a soft, clean surface to prevent scratching. Align the mounting plates of the legs with the pre-drilled holes on the underside of the tabletop. Secure each leg using the provided screws and tighten them with the Allen wrench. Do not overtighten.
[Diagram showing legs being attached to the tabletop.]
Step 2: Install Lower Shelf (if applicable)
If your model includes a lower shelf, position it between the legs at the designated height. Align the holes on the shelf with the corresponding holes on the legs. Insert screws and tighten to secure the shelf.
[Diagram showing the lower shelf being attached to the legs.]
Step 3: Final Tightening and Placement
Once all parts are assembled, gently turn the table upright. Check that all screws and bolts are securely tightened. Ensure the table is stable and does not wobble. Place the table in your desired location.
[Diagram showing the fully assembled table.]
Care and Maintenance
To keep your Yaheetech Hall Table looking its best:
- Wipe clean with a soft, damp cloth.
- Avoid using harsh chemicals or abrasive cleaners.
- Protect the surface from excessive heat and moisture.
Customer Support
For assistance, missing parts, or questions regarding assembly, please contact Yaheetech customer service:
Email: help@yaheetech.shop
