Zempire Bomberpad 3D

2 Year Limited Warranty

Please take time to read about the protection Zempire® Camping Equipment offers. All products come with a guarantee designed to protect you as a valued customer. Zempire® Camping Equipment will repair or replace this product, at their discretion, should it fail due to faulty materials or manufacture for a period of 2 years from the date of purchase.

Conditions of Guarantee:

• The Guarantee only applies to an original purchaser who purchased this product in an unopened condition from an approved retail outlet.
• The Guarantee does not apply if the product has been used for anything other than reasonable personal use. Commercial use (e.g., rental) or continuous use are expressly excluded.
• Damage due to normal wear and tear, accident, acts of God, negligence (other than by Zempire® Camping Equipment), failure by the purchaser to ensure instructions for setting up and care are observed, deterioration due to abnormal exposure to ultraviolet light, damage from wind, insects, animals or mold/mildew, or any other cause reasonably beyond the control of Zempire® Camping Equipment are not covered.
• If redress is sought under the terms of this Guarantee, then the product must be returned by the purchaser to the outlet from where it was purchased within the Guarantee period, in a clean, dry state and with proof of purchase.
• All transport costs and any other indirect costs are excluded from the Guarantee.
• Zempire® Camping Equipment reserves the right to make a reasonable charge for repairs which it determines are not within the scope of the Guarantee.
• The Guarantee does not limit, modify or exclude any rights under any law if doing so would contravene that law or make any part of this Guarantee invalid. However, Zempire® Camping Equipment:
  • excludes (to the extent permitted by applicable law) all conditions and warranties that might otherwise be implied; and
  • limits its liability for breach of any such condition or Guarantee that it cannot exclude together with its liability under the Guarantee, to repairing or replacing the Goods or paying the cost of having the Goods repaired or replaced (at Zempire® Camping Equipment's option).

Australia Only

Goods come with guarantees that cannot be excluded under Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

USA Only

Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

Europe Only

Consumers have legal rights under applicable national legislation governing the sale of consumer goods, and those rights are not affected by the guarantee. All warranty claim processes are explained on the Zempire® website. Please visit www.zempire.co.nz, select your location, and follow the instructions to lodge a warranty claim.

International Distributors

New Zealand & Australia

Zempire® Camping Equipment
6 Karewa Place, Pukete,
Hamilton, 3200, New Zealand
Ph: +64 7 848 1610

United Kingdom, Belgium, Netherlands & Luxembourg

Outdoor & Sports Company Ltd.
Redfern House, Dawson Street
Hyde, Cheshire, SK14 1RD, UK
Ph: +44 161 366 5020

North America

Outdoor & Sports Company Inc.
610 Alden Road Unit 101
Markham, ON, L3R 9Z1, Canada
Ph: +1 905 940 9511

Germany, Austria, & Switzerland

Sport-tech
Goldbeckstrasse 6
69493 Hirschberg, Germany
Ph: +49 6201 8439710

South Korea

Coldspin Corporation
20 Gurodong-ro 15-gil
Guro-gu, Seoul, South Korea
Ph: +82 2 3397 7711

INS-0150702-001D2

Designed and tested in New Zealand. Made with care in China.

For a detailed description of all the features and specifications of this product, please visit our website.

WWW.ZEMPIRE.CO.NZ

INSTRUCTIONS

BEFORE FIRST USE

The first time you use a new mat, it will take longer than normal to inflate. This is because the mat has been stored in a compressed state for an extended period. We recommend taking the following steps before first use:

• Unroll the mat on a flat surface.
• Fully open the valve (refer to diagram A: valve in open position) and allow the mat to self-inflate for up to 30 minutes.
• Turn the valve to inflate mode (refer to diagram B: valve in inflate position) and inflate to maximum capacity by blowing air into the mat with your mouth.
• Once the mat is fully inflated, secure the valve cap (refer to diagram C: valve cap secured) and leave inflated overnight.

NOTE: Inflation speed will continue to improve with use as the foam regains its expanded state "memory".

NORMAL USE

To Inflate:

• Unroll the mat on a flat surface.
• Fully open the valve (refer to diagram A: valve in open position) for maximum airflow. The internal foam will expand, allowing the mat to self-inflate.
• When the mat is fully inflated, turn the valve to inflate mode (refer to diagram B: valve in inflate position). To obtain extra firmness, blow air into the valve with your mouth until the mat has reached your desired firmness.
• Secure the valve cap (refer to diagram C: valve cap secured).

To Deflate:

• Open the valve cap and rotate the valve to deflate mode (refer to diagram D: valve in deflate position).
• Fold the mat in half, then in half again and apply your body weight to expel as much air as possible.
• Unfold the mat and roll towards the open valve, this will force any remaining air out of the valve.
• Close the valve cap (refer to diagram C: valve cap secured), secure the rolled mat with the included compression straps, and insert into the carry bag.

NOTE: Always roll the mat with the grey side facing in to protect the textured fabric. You may need to roll the mat several times to get all the air out. To prevent the mat from self-inflating, make sure the valve is turned to deflate mode (refer to diagram D: valve in deflate position).

TIPS, TRICKS & FAQS

MY MAT WON'T INFLATE

Due to the mat being stored long term in a compressed state, it may not fully inflate on its own. You can inflate to the desired comfort level by blowing a few breaths of air into the mat with your mouth (see 'before first use' instructions).

Do not overinflate your mat. Remember that when you lie on the mat, you displace air. An overinflated mat could cause damage to the fabric. The mat needs to be comfortable but not too hard.

Air temperatures also affect inflation. Cooler temperatures make the mat materials less malleable, potentially increasing inflation time and requiring more breaths of air.

MY MAT DEFLATES OVERNIGHT

When air is colder, it contracts and takes up less space, which can give the impression that the mat is losing air or leaking.

To check for potential leakage, apply some soapy water to the inflation valve and gently apply pressure to the mat, checking for any visible bubbles on the valve.

To check the outer shell, apply soapy water to the mat's outer fabric using a sponge and check for any visible bubbles. Work down the mat, applying pressure as you go to force air towards the sponged area. Repeat on all sides of the mat, including seams and side panels.

IF THE VALVE IS LEAKING

If you find the valve appears to be leaking after a few uses, clean the valve cap and seal. Apply a smear of Vaseline or silicone "O" ring sealer to the inner seal on the mat's screw cap.

MOISTURE TRAPPED INSIDE

If moisture somehow gets inside the mat, follow the deflation steps to remove the "damp" air. Reinflate the mat and store it in a dry, well-ventilated environment with the valve open to allow fresh air to dry the mat.

CARING FOR YOUR MAT

• If your mat must be stored in a rolled state, inflate the mat as frequently as reasonably possible to prevent the foam from developing a compressed state "memory".
• If your mat is accidentally punctured, repair with the included adhesive or use a high-quality, flexible, urethane adhesive.
• To avoid mildew, never store your mat in a damp or wet environment. Ensure your mat is completely dry before storing.
• To clean your mat, use mild soap and warm water. Be sure to close the valve when cleaning to avoid getting water inside the mat. Let the mat air dry. Never place your mat in a washing machine or dryer.
• Keep your mat away from open flames, sparks, embers, hot camp stoves, lanterns, or other high heat sources.
• Avoid using your mat on sharp or abrasive surfaces.
• Do not use an air pump to inflate the mat, as it may cause irreparable damage.
• Be careful not to step on or crush the valve assembly, as this can cause irreparable damage.

IMPORTANT NOTES & WARNINGS

WARNING: This mattress is not designed to be used as a flotation device. Do not use in water. Do not leave children unattended while using the mattress.

WARNING: This mattress is flammable and should not be used near open flame or extreme heat.

IMPORTANT: If being used in a rooftop tent, it is important that your mat is removed from the rooftop tent before folding the tent for travel or storage to prevent damage to the mat.

Recycle Responsibly

• Recycle all packaging material.
• Do not discard into normal household garbage or landfill.
• Please contact local recycling facilities to recycle.