Ride on Lamborghini Sián FKP 37

General Information and Safety Warnings

JAMARA e.K. is not liable for any damage caused to the product itself or through its use, if this is due to improper operation or handling errors. The customer alone bears full responsibility for the proper use and handling, including assembly, charging, use, and choice of operating area. Please refer to the operating and user instructions for important information and warnings.

Age Suitability: Suitable for children over 3 years.

Warning: Not suitable for children under 36 months. Risk of Suffocation! Contains small parts which can be swallowed. Keep away from children.

Due to its top speed, this toy is not suitable for children under 3 years!

Before playing, remove all protective films from all parts.

This product is not intended for use by individuals (including children) with reduced physical, sensory or mental capabilities or lack of experience and/or knowledge. Depending on development, a minimum age of 4 years could be appropriate.

Maximum weight: < 25 kg

Assembly: Adult required for assembly. Keep children away while assembling. Tools needed (not included): Screwdriver.

Safe Driving Practices:

• To prevent accidents and injuries, DO NOT leave your child unattended during operation of the vehicle. Never let your child out of your sight while driving.
• Always sit tight, do not get up during the ride.
• Never take additional children for a ride. (The vehicle is only suitable for 1 person)
• Hold tight.
• Never drive without shoes.
• Never drive in the dark.
• To be used with protective equipment.
• Keep hands, hair, loose clothing and any other item away from any rotating parts.
• Do not operate the model in rooms or halls with high humidity, in the rain or on wet surfaces. Risk of malfunction or damage to electronics and housing.
• The model is not water- or splash-proof. Only operate on asphalted surfaces (such as paving stones). The model is not suitable to be operated in grass or loose soil.
• DO NOT use the vehicle on public roads or places or other dangerous locations. ONLY operate the Ride On Car in places such as private parking, private land or other safe locations. Make sure that no person or animal is endangered.
• The model stops after releasing the accelerator, independently on a horizontal surface. The vehicle has no brake or parking brake. Do not operate the vehicle uphill or downhill, and secure it when parking.

Assembly Instructions

1. Wheel Assembly: Slide washers onto the front and rear axles, attach wheels, secure with nuts, and fit wheel covers. Repeat for all wheels.

2. Steering Wheel Assembly: Connect the steering wheel cable to the model's cable, ensuring no kinks or damage. Align the steering wheel on the steering column, press the pins, and push until it clicks into place.

3. Windshield Assembly: Align the windshield with the corresponding openings on the car body and push into place.

4. Battery Connection: Before assembling the seat, connect all connectors as shown. Ensure correct polarity. Check power by pressing the ON/OFF switch; a motor sound indicates functionality.

5. Seat Assembly: Align the seat diagonally with the car body, insert the hook, and secure with screws at the back.

6. Mirror Assembly: Align the mirrors with the corresponding openings on the car body and push into place.

Charging the Vehicle

The vehicle must be switched OFF during charging.

Insert the charger into the wall socket (LED lights green). Connect the charger to the vehicle's charging socket.

The charger's LED will be red while charging and turn green when fully charged. Charging time is approximately 6 hours. Do not charge more than once within 24 hours. The charger and battery may become warm during charging.

Attention:

• The charger is not a toy. Use only the supplied charger.
• Battery charging must be supervised by an adult.
• Do not short-circuit the terminals.
• Regularly check the charger for damage to the cable, plug, housing, or other parts. Do not use if damaged.
• Allow the model to cool down after each use before operating again. If using a spare battery, allow a 15-minute cooling period between battery changes. Overheating can damage electronics or cause fire.
• Always disconnect the model from the charger immediately after charging. Always disconnect the charger from the power supply immediately after disconnecting the model. Leaving the model or charger connected after charging can cause damage or fire hazards.
• Use the charger only in dry rooms.

Functions

1. Soundboard: Features USB, Micro SD, and Aux inputs for audio playback. Supports .mp3 files. Volume and track control buttons are provided.

2. ON/OFF Switch: Starts and stops the vehicle.

3. Light Button: Controls the vehicle's lights.

4. Speed: High speed and Low speed settings.

5. Shift Lever: Controls forward, stop, and reverse movement. Important: The vehicle must be stationary before changing direction or speed to prevent damage to the gearbox or motor.

6. Foot Pedal: Press to move forward or backward; release to stop.

7. Bluetooth/Radio: Activates Bluetooth for pairing with mobile devices. An acoustic announcement confirms activation. Look for "yx" on your phone to connect.

8. Voltage Display: Shows the battery voltage. If the unloaded voltage drops below approximately 11.8V, the battery needs charging to prevent deep discharge and damage.

Troubleshooting

Refer to the FAQ section on the JAMARA website for detailed troubleshooting information.

Disposal Information

Batteries and accumulators must not be disposed of in domestic waste but must be disposed of separately. Dispose of old batteries at designated collection points. Batteries contain substances that can be irritating, cause allergies, or are highly reactive. Proper disposal is important for the environment and health. If batteries are marked with Hg, Cd, or Pb, they contain more than the specified limits of these heavy metals.

Electrical appliances must not be disposed of in domestic waste and must be disposed of separately. Remove batteries if possible and take the electrical equipment to communal collection points. Remove any personal data from the appliance before disposal.