Haisen UFS Sensor Remote Manual

Key Functions

ON/OFF

Turns the light on or off. If the lamp is turned off before it's short-circuited, it will remain off after power-on again.

Auto Mode

Pressing the "Auto Mode" button activates the sensor, and all settings remain as they were before the light was switched on/off.

Reset

1. Pressing the "Reset" button sets the brightness to the maximum level.
2. Pressing the "Reset" button with DIP switches will control the product via DIP switches. If not, all settings revert to initial values: 100% detection range, 5s hold time, no standby time, and disabled daylight threshold.

+/- Buttons

1. Adjusts brightness from 10-100% in on/off mode.
2. Adjusts the highest brightness from 60-100% in sensor mode.

Start

Pressing "Start" allows users to customize scenes, including detection range, daylight threshold, hold time, standby dimming level, and standby period.

Memory

1. Pressing "Memory" saves all current settings.
2. Settings are retained from the last use if not reset.

Apply

1. Pressing "Apply" delivers the saved setting.
2. Pressing "Apply" without "Memory" will make all settings a one-time operation.
3. Settings must be completed within 30 seconds, otherwise, the device exits memory mode.

Setting Parameters

The remote allows for adjustment of various parameters:

• Detection Area: Press to define detection area (100%/75%/50%/25%).
• Hold Time: Press to define hold time (5s/30s/1min/3min/5min/10min/20min/30min).
• Stand-by Dimming Level: Press to define standby dimming level (10%/20%/30%/50%).
• Stand-by Period: Press to define standby period (0s/10s/30s/1min/5min/10min/30min/+∞). Note: "0s" means no standby period; "+∞" means unlimited standby period.
• Daylight Threshold: Press to define daylight level (2Lux/10Lux/30Lux/50Lux/80Lux/120Lux/Disable). Note: "Disable" means the light turns on with any movement, regardless of ambient light.

Test (2s): The "Test (2s)" button is for post-commissioning testing. Pressing it puts the sensor into test mode with a hold time of only 2 seconds.

HD03R Instruction

Memory & Apply Mode

1. Press the "ON/OFF" button to turn the light on or off.
2. To reset parameters, follow these steps:
   1. Press ON to turn on the light if it was off.
   2. Press "Start" to set the sensor correctly.
   3. Press the buttons for Detection range, Hold time, Stand-by dimming level, Stand-by period, and Daylight threshold sequentially.
   4. Press "Memory" to save the settings.
   Note: The interval between setting each parameter should be within 30 seconds.
3. To program other lights in an array with similar sensors:
   1. Press "ON" to the second sensor.
   2. Press "Apply".

Isolated Setting Mode

1. Press the "ON/OFF" button to turn the light on or off. Press "Auto Mode" to activate settings saved previously or the factory default settings.
2. To reset parameters, follow these steps:
   1. Press ON to turn on the light if it was off.
   2. Press any button among "Auto Mode", "Reset", "Test", and "Apply" to initiate the sensor detection mode.
   3. Press the buttons for Detection range, Hold time, Stand-by dimming level, Stand-by period, and Daylight threshold sequentially.
   Notes:
   1. Settings are saved automatically and remain active until a reset is performed.
   2. The light will flicker when each parameter is being set.