Tow-Trust Towbars
TJEEP1VK JEEP GRAND CHEROKEE (WK) 2011>
Important: Please read General Notes overleaf before fitting
Parts List
| Item | Qty | Description | Item | Qty | Description |
|---|---|---|---|---|---|
| A | 1 | Crossmember | E | 1 | Flip Up Socket Plate TTFP/LH |
| B | 2 | Handed Side Arms | F | 8 | M12 x 35 Bolts & S/P Washers |
| C | 2 | 15mm x 33mm Spacer Tubes | G | 4 | M14 x 40 Bolts, 2 Nyloc Nuts & 2 S/P Washers |
| D | 1 | 6224 ACS Detachable | H | 2 | M8 x 50 Bolts, Nuts & S/P Washers |
| X | 8 | Large Plastic Rivets | J | 2 | M12 x 22 Bolts & S/P Washers |
| K | 2 | M12 x 25 Bolts & S/P Washers | |||
| L | 8 | 12 x 40 Flat Washers | |||
| M | 4 | 8 x 25 Flat Washers | |||
| N | 6 | 14 x 27 Flat Washers | |||
| P | 4 | 12 x 25 Flat Washers |
Bumper Removal
- Remove two fixings from around the boot shut area, two fixings found centrally on the lower edge, four fixings around each wheel arch. OVERLAND BUMPER ONLY carefully release wheel arch trim from vehicle body to reveal an additional bumper fixing. Pull bumper rearward to remove.
- Remove five fixings from the N/S chassis and remove the Towing eye. (Towing eye is NOT refitted with Towbar assembly).
- Remove three fixings from the O/S chassis and carefully remove the rear impact beam. (Rear impact beam is NOT refitted with Towbar assembly).
Towbar Installation
- Insert Items B into each correct chassis member and fix in place using Item F and Item L.
- Using Item G with Item N fix Item A between each side arm (Items B).
- Using Item J with Item P and Item K with Item P fix Item D and Item E to Item A.
- Fully tighten all fixings ensuring the Towbar is rigid, square and secure.
- Cut the bumper centrally 100mm wide x 20mm deep. (Trim to suit)
- Refit the rear bumper using Item C, Item H and Item M to secure the bumper to the bumper tags found on Item A.
- Secure the bumper around wheel arches using Item X.
Diagram Description
The diagram illustrates the Tow-Trust TJEEP1VK towbar assembly for the Jeep Grand Cherokee (WK) 2011>. It shows the main crossmember (A) connecting to the vehicle chassis via side arms (B). Various mounting hardware, including bolts (F, G, H, J, K), nuts, and washers (L, M, N, P), are depicted in their respective positions. The detachable tow ball unit (D) and the flip-up socket plate (E) are also shown attached to the main assembly. The diagram indicates the placement of spacer tubes (C) and plastic rivets (X) used for bumper refitting. Labels on the diagram correspond to the parts list items, showing how the towbar is constructed and attached to the vehicle.
Notes
1. Recommended Torque Setting for M12 Grade 10.9 - 139 Nm. (For other Torque Settings see notes overleaf.)
2. Nose load limits and vehicle manufacturers trailer / caravan weight limits must be observed.
