Sommer Digicode Telecody Quick Start Guide
Remove the security sticker from the digicode. KEEP THE STICKER. Without the reset code written on it, resetting in case of incorrect operation or loss of the code is IMPOSSIBLE.
A. Digicode Activation (to be done only once)
- Press M for 10s
- The yellow and red LEDs will light up for 2s
B. Digicode Learning
- Send an impulse to the receiver button (2 impulses for channel 2), a red LED lights up.
- Press the first digit of your future code.
To be sure the operation was successful, at this stage, a simple impulse on the first digit of your code will start your motor.
Diagram showing a circuit board with labeled points: 3.2, 1, 3.1.
C. User Code Programming
- Press P
- Press the first digit of your code
- Press P
- Enter your entire code
- Press P
Your digicode is now operational.
Image of a Sommer digicode remote with numbered buttons (1-9, 0), ESC, P, M buttons, and indicator lights.
Digicode Reset
- Press M
- Press P
- Enter the 9-digit serial number found on the label
- Press M
- Press P
The two LEDs will light up for 2s.
