NYMÅNE Lighting Fixture
By IKEA
Safety Information
⚠️ IMPORTANT!
- Always shut off power to the circuit before starting installation work.
- In some countries, electrical installation work may only be carried out by an authorized electrical contractor. Contact your local electricity authority for advice.
- Different materials require different types of fittings. Always choose screws and plugs that are specially suited to the material.
Installation Instructions
Step 1: Mount the Bracket
Attach the mounting bracket to the ceiling or wall using appropriate screws and wall plugs. Ensure the screws and plugs are suitable for the mounting material. A magnified view shows a screw being inserted into the bracket and then into the mounting surface.
[Diagram: A person holding a mounting bracket and a screwdriver. A magnified view shows a screw being inserted through the bracket into a wall or ceiling surface. Arrows indicate the direction of insertion.]
Step 2: Prepare the Cable
Feed the power cable through the cable grip.
[Diagram: A power cable being threaded through a cable grip mechanism on the lighting fixture.]
Step 3: Connect Wires to Terminal Block
Insert the wires from the power cable into the terminal block. Ensure correct polarity: Live (L) wire to the 'L' terminal and Neutral (N) wire to the 'N' terminal.
[Diagram: Wires from the power cable being inserted into a terminal block inside the fixture. Terminal labels [L] for Live and [N] for Neutral are visible.]
Step 4: Secure Wires
Secure the wires by tightening the screws on the terminal block (2 screws per connection). The diagram shows a screwdriver tightening the screws.
[Diagram: Close-up view of a screwdriver tightening screws on the terminal block to secure the wires. Two screws are shown being tightened.]
Step 5: Secure Cable Grip
Ensure the cable grip is properly secured by pressing it until it clicks into place.
[Diagram: The cable grip mechanism being pressed until it clicks into place, securing the cable.]
Step 6: Attach Fixture to Bracket
Align the lighting fixture with the mounted bracket. Secure the fixture to the bracket using screws. Arrows indicate upward and inward movement for attachment.
[Diagram: The lighting fixture being lifted and aligned with the mounted bracket. Screws are shown being inserted to fasten the fixture to the bracket.]
Step 7: Install Internal Component
Place any internal components, such as a sensor or driver, into their designated slots within the fixture.
[Diagram: An internal component, possibly a sensor or driver, being placed into its designated slot within the fixture housing.]
Step 8: Close the Cover
Close and secure the fixture's cover or housing.
[Diagram: The fixture's cover being closed and latched.]
Bulb Replacement
ⓘ Information:
When changing the bulb, use only a GU10 LED bulb. Do not use GU10 Halogen bulbs.
[Diagram: Illustrates the process of unscrewing a bulb from a GU10 socket and screwing in a new GU10 LED bulb. Arrows show rotational movement.]
Adjusting the Lamp Head
The lamp head can be adjusted by rotating it to direct light as needed.
[Diagram: Shows the lamp head being rotated in different directions to adjust its angle.]
