LENA LIGHTING BARIS LED Z / BARIS LED N Installation Instructions

Product Identification

Product Names: BARIS LED Z, BARIS LED N

Brand: LENA LIGHTING

Specifications: LED, IP20, IP44, 220-240 V, 50-60 Hz

WEEE Compliance Information

Products are marked in accordance with the European Directive 2002/96/WE and Polish Act on used electric and electronic equipment with a symbol of a crossed-out waste container (?️❌).

This mark indicates that the device, after its useful life, cannot be disposed of with household waste. Users are obliged to return it to authorized collection entities. Proper disposal helps avoid harmful consequences for health and the environment.

Dimensions and Types

The BARIS LED luminaires are available in different lengths. Refer to the table below for dimensions:

[Diagram showing luminaire dimensions labeled A, B, C, and D, with a table listing these dimensions for different product types (510 mm, 1140 mm, 1420 mm).]

Installation Instructions

Step 1: Preparation

Ensure the power is OFF before starting installation. ? [power off symbol]

[Illustration shows the 'POWER OFF' symbol and a hand disconnecting a power plug from a socket.]

Step 2: Mounting

The luminaire can be installed in different versions (Small Version, Big Version). Follow the diagrams for specific mounting hardware and procedures.

[Assembly steps for the 'SMALL VERSION' and 'BIG VERSION' of the luminaire, showing parts labeled A, B, C, D, E and various screws and connectors. Includes 'max!' indicators for screw depth/tightness.]

[Illustration of mounting hardware for the 'SMALL VERSION' and 'BIG VERSION', showing wall anchors and screws. Includes 'max!' indicators.]

[Illustration showing the attachment of a component (likely a driver or connector) using screws, with a 'max!' indicator for screw tightness.]

Step 3: Electrical Connections

Provide basic insulation between the LV supply and control wires.

DALI Control: For luminaires with DALI control, connect the wires as follows:

• L (Live)
• N (Neutral)
• DA+ (DALI Positive)
• DA- (DALI Negative)

[Detailed diagram of DALI control wiring connections for 'ALL VERSIONS'. Shows terminals L, N, DA+, DA- and their corresponding wire connections. Also shows measurement indicators (20mm, 7mm, 7+12mm).]

[Diagram illustrating the wiring and suspension of the luminaire. Shows wires being connected and the luminaire being hung.]

Step 4: Final Assembly

Complete the installation by suspending the luminaire.

[Illustration of the fully installed luminaire hanging.]

Safety and Maintenance

Qualified Personnel

❗ IMPORTANT! Installation and assembly must be carried out by a qualified person only.

Flexible Cord Replacement

If the external flexible cord or cable is damaged, it must be replaced by the manufacturer, their service agent, or a similarly qualified person to avoid risk.

[Diagram illustrating the warning about replacing a damaged flexible cord, showing the cord and indicating replacement by qualified personnel.]

Cleaning

Dirt and dust that settle on the diffuser due to normal operation should be cleaned with a damp cloth. Do not use abrasive cleaners.

[Diagram illustrating cleaning the luminaire diffuser with a damp cloth.]

Light Source Replacement

The light source used in this luminaire should only be replaced by the manufacturer, their maintenance representative, or a similarly qualified person.

[Illustration of the 'POWER ON' symbol.]

Insulation

Ensure basic insulation between the LV supply and control wires. The classification of the insulation maintained between the LV supply and control wires is basic insulation.

Contact Information

LENA LIGHTING S.A.

ul. Kornicka 52, 63-000 Sroda Wlkp.

POLAND

Tel: +48 61 28 60 300

Email: office@lenalighting.pl

Website: www.lenalighting.pl