Introduction
The user will learn how to:
- Remove the device from the case
- Locate the memory card
- Remove memory card
- Insert memory card
Tools and Parts
Tools:
- Can be done by hand; no tools needed.
Parts:
- Memory Card (1)
Replacement Steps
Step 1: Prepare the Device
Action: Release the Case Latch
Important: Power off your device before beginning this SD card replacement.
Use your thumb to push down on the lever marked "[OPEN]" while simultaneously pushing up the latch with your other thumb.
Image Description: Two images show hands manipulating a latch on a clear waterproof case containing a camera. One hand presses down on a lever labeled 'OPEN', while the other hand pushes up on a latch.
Step 2: Remove the Waterproof Case
Action: Separate the Case Halves
Once the latch is free, simply pull the front of the waterproof case off and slide the camera out.
Image Description: Two images show the process of opening the waterproof case. The first shows the latch being released. The second shows the front section of the clear case being pulled away from the camera body.
Step 3: Locate the SD Card Port
Action: Access the SD Card Slot
Locate the micro SD port at the bottom of the device by lifting up the panel.
Image Description: Two images show the camera body. The first shows hands lifting a small panel at the bottom of the device. The second image highlights the exposed micro SD card port.
Step 4: Remove the SD Card
Action: Eject the Micro SD Card
To remove the micro SD card from the device, gently push the SD card and release. The SD card will pop out.
Caution: Be sure to gently push the SD card. Pushing harder than necessary can cause the SD card or port to break.
Image Description: Two images demonstrate removing the SD card. In the first, a finger gently pushes the edge of the micro SD card. In the second, the card is shown partially ejected from its slot.
Step 5: Insert the New SD Card
Action: Place the New Card
When putting a micro SD card back into the device, be sure to place the exposed metal side up, as well as have the device LCD screen side up.
Image Description: An image shows a hand holding a micro SD card, preparing to insert it into the device's SD card slot. The card is oriented with its metal contacts facing upwards.
Step 6: Secure the SD Card
Action: Insert and Click the Card
Gently push the micro SD back into the SD port until you hear a click!
Note: Do not push the SD card hard. If it doesn't click, you may have the card inserted the wrong way. Too much pressure can break the SD card or the SD port.
Image Description: An image shows a finger pushing a micro SD card into its slot. The text indicates that the card should click into place.
Reassembly
To reassemble your device, follow these instructions in reverse order.
