Next Level Racing ES1 Instruction Manual
Take Racing to the Next Level®
Your Racing Journey Starts Here
We know you're eager to start flying! Take your time with the instructions and follow this guide to assemble your product. You'll be setting yourself up for success by following the instruction booklet to fully optimize your product.
For assembly video, scan the QR code. Scan the QR code to join our social media communities.
Video Instruction: bit.ly/nlrbuild
Follow Us:
- Instagram: @next_level_racing
- Facebook: @nextlevelracingOfficial
- Twitter: @nextlvlracing
- YouTube: Next Level Racing
- Email: support@nextlevelracing.com
Pre-Race Checks
WARNING
- Please do not use power tools for assembly as over-tightening can damage your seat and hardware.
- Make sure all mounting points are aligned correctly to avoid twisting your seat or frame.
If you require any support with your product, please contact our friendly team at: support@nextlevelracing.com
WARNING
CHOKING HAZARD - Small parts not for children under 3 years or any individuals who have a tendency to place inedible objects in their mouths.
Video Instruction: bit.ly/nlrbuild
In The Box
Check if all parts are included in the box.
Parts Included:
- 6 x M8 20MM Bolts
- 6 x M8 Washers
- 1 x Harness
- 1 x ES1 Seat
Seat Mounting Hole Pattern/Dimensions
See below mounting hole patterns and dimensions for the ES1 seat. Useful if you need to bottom mount your seat or mount your seat in an unconventional way.
Dimensions:
- Width: 285.00mm
- Depth: 285.00mm
- Height: 85.00mm
- Side Mount Width: 355.00mm
- Bottom Mount Width: 300.00mm
- Hole Spacing: 60.00mm
Assembly Instructions
1.0 Bolt Universal Seat Bracket to Seat
Refer to the image. Repeat on the other side. Use 2 x 20MM M8 Bolts and 2 x Washers.
For bottom mount option, go to page 8.
2.0 Feed Supplied Seat Harness Through Holes Shown & Bolt to Seat
Refer to the image. Repeat on the other side. Use 2 x 20MM M8 Bolts and 2 x Washers.
3.0 Completed Seat Ready to Install on Your Cockpit
Refer to the image.
To Mount Your Own Seat Rails
1.0 Bolt Seat Bracket to Underside of Seat
Refer to the image. You will require 4 x 20MM M8 Bolts and 4 x Washers.
2.0 You Can Now Bolt Seat Slider to Cockpit of Your Choice
Refer to the image.
WARNING
Please do not use power tools for assembly as over-tightening can damage your seat and hardware. Make sure all mounting points are aligned correctly to avoid twisting your seat or frame.
ASSISTANCE
If you require further support with your product, please contact our friendly team at: support@nextlevelracing.com
Video Instruction: bit.ly/nlrbuild
Notes
Notes section for additional information.