Yaheetech 613629(Full) Bed Frame Assembly Instructions
Important Information
General Advice:
- Recommended People: 2 or more people for installation.
- Estimated Assembly Time: 1 hour.
- Safety Warnings:
- Not intended for use by children.
- Keep away from fire or other heat sources.
- We recommend wearing protective gloves during assembly.
Assembly Tips:
Please follow the instruction manuals and use a pad to avoid damage during assembly. Ensure the product and floor are protected during installation.
Parts List
Please refer to the diagrams for visual identification of parts.
Main Components:
- A: Headboard (x1)
- B: Bed Frame Side Rail (x1)
- C1: Left Side Rail Connector (x1)
- C2: Left Side Rail Connector (x1)
- C3: Right Side Rail Connector (x1)
- C4: Right Side Rail Connector (x1)
- D1: Left Leg Post (x1)
- D2: Right Leg Post (x1)
- E: Center Support Rail (x1)
- F: Slat Support Bar (x2)
- G: Slat Support Bar (x1)
- H: Support Bracket (x2)
- I: Support Bracket (x1)
- J: Support Bracket (x2)
- K: Support Bracket (x2)
- L: Corner Bracket (x1)
- M: Bed Slats (x2)
- N: Foot (x2)
Hardware:
- O: Screws (M8*20mm) (x20)
- P: Screws (M8*25mm) (x2)
- Q: Screws (M8*40mm) (x6)
- R: Screws (M8*50mm) (x1)
- S: Allen Wrench (x1)
Assembly Steps
Step 1: Attach part A (Headboard) to part Q using screws (1) and Allen wrench (S). Initially, half-tighten all screws. After all screws are in place, fully tighten them.
Step 2: Connect parts P to part A using screws (1) and (2). Attach part D1 and D2 to the frame using screws (1) and (2).
Step 3: Attach part G to the frame using screws (2).
Step 4: Assemble the side rails. Connect parts C1, C3, H, K, and L using screws (1). Pay attention to the orientation of parts as shown in the diagrams.
Step 5: Connect parts C2, C4, H, K, and R using screws (1). Ensure correct alignment.
Step 6: Attach parts N to the frame using screws (1). Ensure the correct orientation of part N.
Step 7: Attach part B to the frame. Do not fully tighten screws at this stage. Follow the detailed steps for connecting various parts of the frame.
Step 8: Attach center support rail E to the frame using screw (4).
Step 9: Attach support brackets H to the frame using screws (3).
Step 10: Attach slat support bars F to the frame using screws (3).
Step 11: Secure all remaining connections by fully tightening all screws.
Step 12: Place bed slats M onto the frame.
Step 13: Final check of all connections.
Customer Support
If you are not entirely satisfied with your purchase, please contact Yaheetech customer service. Follow these steps:
- Go to Your Orders.
- Find your order in the list.
- Select "Problem with order".
- Choose your topic from the displayed list.
- Select "Contact seller".
You can also download the electronic Installation Manual from the "Product guides and documents" section of the advertising page.
