Important Information and Assembly Guide
General Safety and Assembly Recommendations
? We recommend 2 or more people to install.
⏱️ The expected assembly time is 1 hour.
?? Not intended for use by children.
? Keep away from fire or other heat sources.
? We recommend wearing protective gloves.
Please follow the instruction manuals and use a pad to avoid damage during assembly. Protect the product and the floor during installation.
Parts List
| Part Identifier | Description | Quantity |
|---|---|---|
| 1 | Side Rail | x2 |
| 2 | Side Rail | x2 |
| 3 | Headboard/Footboard Component | x2 |
| 4 | Support Beam | x2 |
| 5 | Support Beam | x2 |
| 6 | Support Beam | x2 |
| 7 | Central Support | x1 |
| 8 | Support Rod | x8 |
| 9 | Headboard/Footboard Component | x1 |
| 10 | Cross Support | x2 |
| 11 | Slats | x4 |
| 12 | Slats | x2 |
| A | M8*65mm Screw | x4 |
| B | M8*35mm Screw | x4 |
| C | M6*60mm Screw | x10 |
| D | M6*40mm Screw | x20 |
| E | M6*30mm Screw | x8 |
| F | Hardware | x4 |
| G | Hardware | x4 |
| H | Hardware | x4 |
| I | M6 Nut | x16 |
| J | Hardware | x8 |
| K | Washer | x14 |
| L | Wrench/Allen Key | x1 |
Assembly Steps
Step 1
Attach two side rails (part 1) to the headboard/footboard component (part 3) using four M6*60mm screws (part C) and four washers (part K). Half-tighten all screws.
Step 2
Attach the other two side rails (part 2) to the headboard/footboard component (part 3) using four M6*60mm screws (part C) and four washers (part K). Half-tighten all screws.
Step 3
Attach support beams (parts 4, 5, 6) to the side rails. Use two M8*35mm screws (part B) and two hardware pieces (part H) for each beam. Half-tighten all screws.
Step 4
Attach the central support (part 7) and two cross supports (part 10) to the frame. Use one M6*40mm screw (part D) and one hardware piece (part J) for each connection point. Half-tighten all screws.
Step 5
Attach the legs (parts 1 and 2) to the frame. Use four M8*65mm screws (part A), four hardware pieces (part G), and four washers (part K) for each leg assembly. Half-tighten all screws.
Step 6
Attach the slats (parts 11 and 12) to the frame. Use four M6*30mm screws (part E) and four washers (part K) for each slat. Half-tighten all screws.
Step 7
Tighten all screws completely after the assembly is finished.
Customer Support and Manual Download
If you are not entirely satisfied with your purchase, please feel free to contact Yaheetech using the following steps:
- Go to Your Orders.
- Find your order in the list.
- Select 'Problem with order'.
- Choose your topic from the list displayed.
- Select 'Contact seller'.
You can also download the electronic Installation Manual from the 'Product guides and documents' section of the advertising page.
