Cycplus A10 Portable Air Pump

1. In the Box

• 1) Air Pump
• 2) Air Hose
• 3) Type-C Charging Cable
• 4) Valve Adapter
• 5) Ball Adapter

2. Details

Pump Head Details:

Vent Port: A circular opening with internal threads for connecting to a valve stem.
Type-C Charging Interface: A standard USB Type-C port for charging.
LED Light: A small circular indicator light.

Pump Body Details:

POWER Button: For turning the device on/off and starting/stopping inflation.
LED Screen: Digital display showing pressure, mode, and battery status.
UNIT Button: Cycles through pressure units (PSI, BAR).
Light Switch: Controls the LED light.
- Button: Decreases pressure or cycles through modes.
+ Button: Increases pressure or cycles through modes.

3. Button Functions

• POWER Button: Press for Start/Stop Pumping; Long press for Power On/Off.
• UNIT Button: Select Mode; Cycles through pressure units (PSI/BAR).
• Light Switch: Turn Lighting On/Off (Screen On); Turn Lighting Unit On/Off (Screen Off).
• + Button: Increase Pressure (Rapid Increase on long press).
• - Button: Decrease Pressure (Rapid Decrease on long press).

4. Pumping Guide

5. Valve Installation

Inflatable Interface: The connection point for the air hose.
Valve Type: Indicates compatibility with different valve types.

• American valve (Schrader type)
• French valve (Presta type)
• Ball (Needle adapter)

6. Procedure

1. Long press the POWER button to turn on the pump. The LED lamp will display the current pressure.
2. Long press the UNIT button to switch between pressure units (PSI and BAR). Short presses allow cycling through five usage modes: Custom, Car, Motorcycle, Bicycle, and Basketball. Common pressure values are preset for each mode.
3. The '+' and '-' buttons adjust the preset pressure value. Holding them allows for rapid adjustment (in custom mode, the device remembers the last set pressure).
4. Press the POWER button to start pumping. Press it again to pause/resume. The pump automatically stops when the target pressure is reached.

7. Charging

1. For the first use, or if the pump has not been used for a long time, charge it before use.
2. The charging indicator lights up red while charging and turns green when the battery is fully charged.
3. The air pump should typically be charged every two months, even if not in use. Prolonged periods without charging can lead to battery discharge and damage.

8. Notes

1. It is normal for the air pump to become warm after more than 1 minute of operation. Please do not touch the hot part of the air hose! ♨️
2. Inspect the air pump before use. Do not use it if you find any abnormalities.
3. If you hear abnormal noises or experience excessively high temperatures during pumping, stop using it immediately.
4. Ensure the airflow is consistent during pumping.
5. The compressor can produce electric sparks during operation. Keep it away from flammable and explosive materials.
6. Do not pull the hose or power cord to prevent accidents during pumping.
7. After prolonged use, both the air pump and the air hose will become warm. Take a break before using it again.
8. Please try to avoid dirt/dust ingress, soaking, and dropping the device.
9. Do not use strong chemicals, detergents, or cleaning agents for cleaning.
10. Do not store the air pump in cold, hot, or humid conditions.
11. Children are not permitted to use the air pump. Keep out of reach of children.
12. Do not blow air into people's or animals' mouths, ears, or eyes.
13. It is not recommended to pump while charging.
14. [Note] When the air pump is operating, the high current draw may affect battery readings; this is for reference only.

9. Specifications