Assembly Instructions
WF288113/WF288114
IMPORTANT NOTE
- PLACE ALL PARTS ON A CLEAN AND SMOOTH SURFACE SUCH AS A RUG OR CARPET TO AVOID THE PARTS FROM BEING SCRATCHED.
- BEFORE YOU BEGIN, KINDLY FOLLOW THE ASSEMBLY INSTRUCTIONS STEP BY STEP.
- DO NOT TIGHTEN ALL SCREWS AND BOLTS UNTIL THE BED IS FULLY SET-UP.
The image shows a daybed with a trundle. The main bed has a curved headboard and footboard with decorative tufting. The trundle unit is positioned underneath the main bed.
PARTS IDENTIFICATION
| PART | DESCRIPTION | QUANTITY |
| 1 | Bed Panel | 2pcs |
| 2 | Leg | 4pcs |
| 3 | Roll Slat (10pcs) | 2set |
| 4 | Headboard Panel | 1pc |
| 5 | Left Upper Rail | 1pc |
| 6 | Back Panel Trundle | 1pc |
| 7 | Right Upper Rail | 1pc |
| 8 | Front Panel Trundle | 1pc |
HARDWARE IDENTIFICATION
B1(BOX1) HARDWARES IN WF288113(B1)
| ID | DESCRIPTION | QUANTITY |
| A | Flat Head Screw (m4x15mm-RBW) | 40pcs |
| B | Flat Head Screw (m4x30mm-RBW) | 40pcs |
| C | Wheels (m59x42mmx66mm) | 4pcs |
| D | Square Patch (38mmx38mmx25mmx2mm) | 4pcs |
B1(BOX1) HARDWARES IN WF288114(B2)
| ID | DESCRIPTION | QUANTITY |
| E | Bolt (Ø 5/16 "X25mm) | 16pcs |
| F | Spring Washer (Ø 5/16 "-RBW) | 16pcs |
| G | Flat Washer (Ø 5/16 "-RBW) | 16pcs |
| H | Allen Wrench (M4x75mm x32mm) | 1pc |
| I | Patch (100mmx40mmx2mm) | 4pcs |
ASSEMBLY INSTRUCTIONS
STEP 1
Attach the legs (2) to the bed panels (1). The diagram shows two bed panels, each with two legs being attached to the underside. The legs are cylindrical.
STEP 2
Connect the left upper rail (5) and right upper rail (7) to the bed panels (1). The diagram shows the main bed frame being assembled. Hardware E (Bolt), F (Spring Washer), G (Flat Washer), and H (Allen Wrench) are used for this step. A close-up view shows how the bolt, washers, and allen wrench are used to secure the rails to the bed panels.
STEP 3
Attach the headboard panel (4) to the assembled bed frame. The diagram shows the headboard being attached to the side panels. Hardware E (Bolt), F (Spring Washer), G (Flat Washer), H (Allen Wrench), and I (Patch) are used. A close-up view illustrates the connection points and hardware usage.
STEP 4
Assemble the trundle unit. Attach the back panel trundle (6) and front panel trundle (8) to the trundle frame. Hardware A (Flat Head Screw), B (Flat Head Screw), and D (Square Patch) are used. The diagram shows the trundle frame being constructed, with close-ups detailing the screw and patch attachments.
STEP 5
Attach the wheels (C) to the trundle unit. Hardware A (Flat Head Screw) is used to secure the wheels. The diagram shows the underside of the trundle with wheels being attached to the corners.
STEP 6
COMPLETE. The final diagram shows the assembled daybed with the trundle unit pulled out, demonstrating the complete setup.
