JOINON WALLBOX I-CON BASIC
Quick Installation Guide
Product Overview
This guide provides instructions for the installation of the JOINON WALLBOX I-CON BASIC, an electric vehicle charging station manufactured by GEWISS.
Diagram 1 & 6: Illustrates the JOINON WALLBOX I-CON BASIC unit, shown wall-mounted with its charging cable connected.
Diagram 2: Shows a person holding the wallbox unit and the installation manual, with a QR code nearby, suggesting access to digital resources.
Diagram 3: Presents an exploded view of the wallbox components, detailing how they assemble.
Diagram 4: Displays a QR code, likely linking to further product information or support.
Installation Steps
Follow these steps for proper installation:
-
Mounting Bracket Installation:
Diagram 5, Step 2 & Diagram 7, Step 2: Shows the wall mounting bracket.
Diagram 5, Step 3 & Diagram 7, Step 3: Depicts attaching the mounting bracket to the wall using appropriate hardware (screws, anchors).
Diagram 8: Illustrates a person positioning the wallbox unit against the wall for mounting.
-
Wallbox Mounting:
Diagram 5, Step 4 & Diagram 7, Step 4: Shows the wallbox unit being attached to the previously installed mounting bracket.
-
Electrical Connections:
Diagram 9 (Page 2, Top Left): Highlights an access point (arrow 'A') on the top of the wallbox for electrical connections.
Diagram 10 (Page 2, Top Right): Shows the interior of the wallbox, featuring a warning symbol ⚠️ and the terminal block for electrical wiring. It also indicates "DC LEAK" detection.
Diagram 11 (Page 2, Bottom): Provides wiring diagrams:
- Single-phase connection: L1, N, PE (Live, Neutral, Protective Earth).
- Three-phase connection: L1, L2, L3, N, PE (Live phases 1, 2, 3, Neutral, Protective Earth).
-
Final Installation:
Diagram 5, Step 5 & Diagram 7, Step 5: Shows the completed installation of the wallbox unit.
Technical Information
Product Code: cod. 7.55.4.541.8
Last Revision: 05/2021 (Italian: ULTIMA REVISIONE 05/2021)
