LIAN LI UNI FAN SL WIRELESS 120
Installation Guide
Package Contents
The package includes the following items:
- 1 x UNI FAN SL WIRELESS 120 Fan
- 1 x Accessory Pack (containing screws and other necessary components)
Fan Installation and Setup
Removing the Fan Interlocking Key
If the radiator outlet interferes with the fan interlocking key, you can remove it by pressing the release tab and pulling the key out.
Usage of the Rubber Pads
Secure the fan to the radiator and cover the mounting points with the provided rubber pads to enhance the overall aesthetics.
Fan to Fan Connection
Fans can be connected in series (daisy-chained) for simplified wiring. Each group (channel) can support a maximum of:
- 4 x UNI FAN SL Wireless fans
- 3 x UNI FAN SL Wireless LCD fans
- A mix of UNI FAN SL Wireless and LCD fans, up to a total of 4 fans (with a maximum of 2 LCD fans).
Use the release tabs to disconnect fans when needed.
Cable Organize (Shorten)
Measure the required cable length for your setup and organize or coil any excess cable neatly to maintain a clean build.
L-Wireless Receiver and Controller Setup
Switching Cable Orientation on the L-Wireless Receiver
The L-Wireless receiver allows for cable orientation changes. Use the release tabs to switch the orientation of the connected cables.
L-Wireless Receiver Installation
Install the L-Wireless receiver into your system. Please be mindful of the direction when installing, as the sockets for the power module are different in size to ensure correct connection.
Ensure the connection is secure.
Fan Cable Connection
Connect the fan's PWM cable to the corresponding PWM fan header on your motherboard for speed control.
L-Wireless Controller Installation Guide
Models: RF-T-B / RF-T-W
Each L-Wireless Controller supports up to 10 channels of devices, allowing for comprehensive control of your UNI FANs.
Method 1: Controller Connection
Connect the controller to a PWM fan header and a USB 2.0 header on the motherboard.
Method 2: Controller Connection
Connect the controller to a PWM fan header and a USB 2.0 header on the motherboard.